Unpacking The Device; Power Sources - LEXIBOOK SMBABY1 Instruction Manual

uctions. When unpacking, ensure that the following elements are included:
1 x baby unit
1 x parent unit
1 x DC adapter
1 x instruction manual
er
WARNING: All packaging materials, such as tape, plastic sheets, wire ties and tags are not part of
this product and should be discarded.
d plug
and a
Baby Unit
If
The SMBABY1 baby unit operates with  x C size 1,5V
of the
20V – 50Hz.
nience AC operation
1. Check that the unit is switched off.
2. Connect one end of the adapter to the DC IN jack located on the right side of the unit.
. Plug the other end of the adapter into any convenient AC 20V – 50Hz power outlet.
Battery installation
it has
1. Using a screwdriver, open the two battery compartments
s been
located at the back of the baby unit.
t has
2. Insert 2 x C size batteries (not included) in each
compartment observing the polarity indicated in the
compartments, and as per the diagram shown opposite.
ith
. Close the battery compartments and tighten the screws.
Note: The adapter must be disconnected from the
DC IN jack on the rear of the unit in order to let the
product operate on battery power.
Parent Unit
n to
The SMBABY1 parent unit operates with  x AA/LR6 size 1,5V
AC 20V – 50Hz.
AC operation (adapter not included)
1. Check that the unit is switched off.
2. Connect one end of the adapter to the DC IN jack located on the left side of the unit.
. Plug the other end of the adapter into any convenient AC 20V – 50Hz power outlet.

Unpacking the device

Power sources

batteries (not included) or on AC
batteries (not included) or on
1