PRIXTON RUN FIT COMPACT RF110 Operation Manual page 14

3. Do not allow for the running belt to catch the sides of the Confidence Power Electric
Tread mill as this will tear the belt.
CARE, MAINTENANCE & TROUBLESHOOTING GUIDE
WARNING: To prevent electrical shock, please turn off and unplug the treadmill before
cleaning or performing routine maintenance.
WARNING: Always check the wear and tear components like spring knob and running
belt to prevent injury.
CLEANING
After each exercise, ensure that the unit is wiped down and any sweat is removed
from the unit.
The treadmill can be cleaned with a soft cloth and mild detergent. Do not use abrasives
or solvents. Be careful not to get excessive moisture on the display panel as this might
damage the unit and create an electrical hazard.
Please keep the treadmill, especially the computer console, out of direct sunlight to
prevent damage to the screen.
STORAGE
Store the treadmill in a clean and dry indoor environment. Never leave or use the unit
outdoors. Ensure the master power switch is off and the power cord is un-plugged from
wall outlet.
Problem:
Treadmill will not start.
Potential Causes:
1.Treadmill not plugged in.
2.Safety Tether Key is not correctly installed.
3.Circuit breaker in the house has been tripped.
4.Treadmill circuit breaker has been tripped.
Corrections:
1.Plug the power cord into a wall outlet.
2.Reinstall the Safety Tether Key.
3.Reset the circuit breaker, or call an electrician to replace the circuit breaker.
4.Wait 5 minutes and then try to restart the treadmill.
Problem:
Belt slips.
Potential Causes:
Belt not tight enough.
Corrections:
Adjust belt tension.
Problem:
Belt hesitates when stepped on.
Potential Causes:
1.Not enough lubrication applied onto the running deck.
2.Belt is too tight.
Corrections:
1.Apply lubricant.
2.Adjust belt tension.
Problem:
Belt is not centred.
Potential Causes:
Running belt tension not even across the rear roller.
Corrections:
Centre the belt.
14