Solar Centre RICHMOND User Manual

W E
S
Do NOT place your
Ensure your solar Do NOT charge
Clean your solar
solar panel in shaded
panel is South facing panel from time behind glass
or as near as possible areas.
to time
Always take care when setting up your light especially when you are mounting it in high places.
User Guide
Thank you for choosing The Solar Centre's Richmond Solar Garden Pull Cord Light. Please read these
instructions carefully before using your light.
Please note that your Richmond is designed to charge by day and work by night. It is possible to use your light
during the day, but it will not charge while you are using it. Regular daytime use for extended periods will result
in your light running flat.
Installing the Solar Panel
Please note that the light can be used indoors or outdoors, but the solar panel must always be installed
outside.
Before installing your light in your desired location, you'll need to consider the best place for the solar panel to
receive the most amount of daylight. There is 3 metres of cable between the solar panel and the ceiling
mount so it is essential you do not position the solar panel out of reach of where you want your light to go.
When positioning the solar panel always try to angle it south, south-east or south-west while avoiding places
where daylight is obstructed by buildings, fences, trees or the shadows that these create. Once you have
identified your solar panel location, install it using the supplied screws and rawl plugs.
Installing the Light
Before installing your light, remember that the pull cord is 23cm long so please ensure that you are able
to reach it in the location you intend to install it in. Hold the ceiling mount in place and mark the 3 holes. You
can now either drill those marks or use an awl to create the holes depending on what surface you are
mounting the light to. When you are ready, screw the ceiling mount into place.