Advertisement
Quick Links
PANOPTIX
Important Safety Information
See the Important Safety and Product Information guide in the chartplotter or fishfinder product box for product
warnings and other important information.
To obtain best performance and to avoid product damage and potential injury, you must install this mount using
these instructions.
NOTE: Read all installation instructions before proceeding with the installation. If you experience difficulty
during the installation, go to
Battery Warnings
The Garmin
device uses a user-replaceable, sealed, lead-acid battery. If these guidelines are not followed, the
®
battery may experience a shortened life span or may present a risk of damage to the device, fire, chemical burn,
electrolyte leak, and/or bodily injury.
• Do not place the battery near objects that may cause sparks, flames, or heat.
• Do not incinerate the battery.
• Do not use a sharp object to remove the battery.
• Do not disassemble, puncture, or damage the battery.
• Do not swallow, touch, or inhale the contents of an open battery. Avoid contact with internal acid. Contact
with internal acid may cause irritation or severe burns. Irritation may occur to the eyes, respiratory system,
and skin. Flush with water at once if contact is made with acid.
• Do not submerge the battery and avoid contact with water.
• Do not short the battery terminals.
• Do not drop or throw the battery.
• Keep the battery away from children.
• Only replace the battery with the correct replacement battery. Using another battery presents a risk of fire or
explosion of the device or charger.
• Only use the included Garmin 12 Vdc charger.
• Do not charge the battery in an unventilated area.
• Store in a cool, dry, and well-ventilated area.
• Do not charge the battery in a gas-tight container.
• Do not leave the device exposed to a heat source or in a high-temperature location, such as in the sun in an
unattended vehicle. To prevent damage, remove the device from the vehicle or store it out of direct sunlight.
• Do not use organic solvents or other cleaners other than recommended chemical cleaners on the battery.
• Contact your local waste disposal department to dispose of the battery in accordance with applicable local
laws and regulations.
• When storing the battery for an extended time, store within the following temperature range: from 5° to 104°F
(from -15° to 40°C).
• Do not operate the battery outside of the following temperature range: from 5° to 122°F (from -15° to 50°C).
June 2024
PS22-IF ICE FISHING KIT AND BUNDLE
™
INSTALLATION INSTRUCTIONS
support.garmin.com
for more information.
WARNING
WARNING
GUID-BA17B618-5549-448B-BA85-6A67EE97CA35 v2
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Garmin Panoptix PS22-IF
Summary of Contents for Garmin Panoptix PS22-IF
- Page 1 • Only replace the battery with the correct replacement battery. Using another battery presents a risk of fire or explosion of the device or charger. • Only use the included Garmin 12 Vdc charger. • Do not charge the battery in an unventilated area.
-
Page 2: Battery Tips
Battery Tips • The length of time a fully charged battery will last before fully discharging varies based on many factors, such as device backlight brightness, the temperature, and the age of the battery. • You can lower the backlight brightness level to help extend the battery life. •... -
Page 3: Assembling The Mount
Assembling the Mount The portable mount is preassembled in the ice fishing bundle. This step is only required for the ice fishing kit. 1 Press the M6 nut into the bottom of the swivel-mount base NOTE: If you purchased your chartplotter or fishfinder device separately, use the swivel-mount base and bail mount bracket included with your device. - Page 4 Placing the Portable Mount in the Bag After you have assembled the portable mount, you should place it in the bag, which makes it easier to carry and protects it from the elements. The bag contains loops that allow you to tether the bag as needed. 1 Place the portable mount into the bag.
- Page 5 Adjusting the Transducer Angle The transducer should be angled properly for optimal imagery in each mode. 1 With the transducer mounted, angle the transducer according to the mode you will use: • For LiveVü Forward mode, angle the transducer forward and slightly downward •...
-
Page 6: Beam Width
Beam width When you point the transducer away from the bottom, the integrated stabilization system automatically aligns the beam vertical to the bottom. Regardless of the transducer orientation, the length cone angle is always 120°, and the width cone angle is 12°... -
Page 7: Specifications
From -15° to 40°C (from 5° to 104°F) temperature range Battery storage From -15° to 40°C (from 5° to 104°F) temperature range Panoptix PS22-IF Specifications Dimensions (W x H x L) 66 x 228.6 x 101.6 mm (2.6 x 9 x 4 in.) Transducer weight 680 g (1.5 lb.) Total weight (transducer, mount, and cable) 1150 g (2.54 lb.) - Page 8 © 2024 Garmin Ltd. or its subsidiaries Garmin and the Garmin logo are trademarks of Garmin Ltd. or its subsidiaries, registered in the USA and other countries. ECHOMAP and Panoptix are trademarks of ® ™ ™ Garmin Ltd. or its subsidiaries. These trademarks may not be used without the express permission of Garmin.
Need help?
Do you have a question about the Panoptix PS22-IF and is the answer not in the manual?
Questions and answers