Precautions - Aiwa CT-X417 Operating Instructions Manual

PRECAUTIONS
Ensure to remove the cassette tape from the
cassette compartment of the unit when you are
not using the unit.
Do not let cassette tapes come m contact with
direct sunlight, diri or dust. Do not touch the
tape inside a cassette as doing so may
contaminate the tape surface.
Do not leave cassette tapes near electrlc motors
or magnets. Store them separately to avoid
unwanted noise or loss of tone quality,
Use acleamng cassette to clean the playback
head and capstans approximately once a month.
If the playback head is dirty, the high tone sound
may not be reproduced properly.
Keep screwdrivers etc. or other metallic or
magnetic objects away from the playback head.
When your car is parked under dtrect sunlight m
summer, there may be a considerable nse m
temperature inside the car. Ensure to let the
ambient temperature cool down before playing
a cassette tape.
This unit is designed to be operated on a 12 volt
DC negative ground electrical system only.
*When replacing the fuse, be sure to use the fuse
whose amperage rating is identical. Use of a
fuse with higher amperage may cause serious
damage to the unit.
CAUTION
There is a transit protection pad in the cassette
compartment,
Be sure to remove the pad and push the eject
button before operating the umt.
Transit protection pad
SECURITY LAMP
The LED lamp on the front side of umt is vmble
when the control panel E detached. This lamp
continues to flash to deter theft while the car's
Ignition key IS turned off with the control panel
detached. However, this unit is not equipped with
the security alarm system that sounds an audible
alarm, therefore there are limitations to this antl-
theft dewce.
EN
3