PUR PFM400H Manual

PUR Chrome Horizontal Faucet Filtration System PFM400H
•
Question: How do I install my faucet system?
Answer:
Please refer to
1. Remove your original aerator and its washer. Use a rubber jar opener if the aerator is difficult
to remove.
2. Identify your faucet threading – either external or internal.
3. Attach the device to your faucet.
•
Question: How do I reset the filter light?
Answer:-
1. Remove filter and place back into unit.
2. Push the reset button in for 3 seconds until all 3 lights flash, then release.
3. Make sure reset button is not stuck in. If reset button is stuck, pull up on button so it springs
back into place
• Check to make sure old aerator washer was removed and only the new adapter washer is being used. •
If the enclosed adapters do not fit, contact PUR Consumer Relations at 1-800-PUR-LINE (1-800-787-
5463).
Adapters don't fit / won't stay attached / keep falling off.
Water leaks out around the filter cover. Slow water flow in the filtered position. Water leaks around the
faucet adapter and faucet.
• Remove the filter cartridge and reinstall the filter cartridge again. • Replace the filter cartridge.
Difficulty in removing the old filter cartridge to replace the filter.
• Check to see that the washer was placed on top of the faucet adapter when installed. • Make sure the
adapter is hand-tightened securely to the faucet. • Make sure the unit is securely attached to the faucet
adapter. • Remove the filter system unit from the faucet by squeezing the quick release buttons. •
Remove the cover. • Slowly turn or twist the filter cartridge. This will help loosen the filter.
Technical Specifications:
FILTER CAPACITY: 100 gallons (378 liters)/up to 3 months
RATED SERVICE FLOW: 0.52 gallons/minute (2.0 liters/minute) at 60 psig
MAXIMUM TEMPERATURE: 100°F (38°C)
MINIMUM TEMPERATURE: 34°F (1°C)
MAXIMUM WORKING PRESSURE: 100 psig (690 kPa)
https://youtu.be/5UKBfQw7Ci0
Trouble Shooting Steps
and the steps below: