Panasonic NE-SCV2 Operating Manual

Tools
Memory cooking
Initial screen
Maintenance info.
Change settings
Check memory
Memory lock
Refer to the Operating Instructions.
OWhen the memory lock is ON, Memory cooking
In such cases
●Regular maintenance
A part replacement is required when a screen displays that it is time to perform the regular maintenance. Please
contact the dealer or a service agent promptly.
●"F" code e.g. "F30" etc.
If the "F" code does not disappear even after pressing the Stop/Reset pad, pull out the plug and then plug it in
again after 5 seconds.
The oven is faulty if the "F" code still appears. Contact the dealer or a service agent.
●The power turns off automatically
The initial screen of the display turns off automatically if it is not used for 5 minutes. (Auto Power OFF Function)
Opening the door turns the power ON.
A total of all cooking hours is rounded down to the nearest hour.
ex.) All cooking hours Display
59 min 0
1 hr 59 min 1
The last two figures of the total number of cycles are rounded down.
ex.) Number of cycles Display
99 times 0
101 times 100
1100 times 1100
The settings of the beep
●Loudness ●Length of beep ●Pitch of beep ●Sounds
ON: You can start cooking before preheating is complete.
OFF: You cannot start cooking until preheat is complete.
You can choose the brightness of the touch screen.
You can change the preheat temperature displayed on the initial
screen.
OPlease note that the preheat temperature previously saved for the
memory cooking will also be changed if you change the setting here.
Confirm the following memory contents.
●Memory cooking contents ●Beep settings ●Memory lock
●Magnetron interval ●Maintenance interval
Use to confirm whether the contents of multiple SD Memory
Cards are the same.
The memory contents in the SD Memory Card are displayed as
four-figure alphanumeric characters.
(Default setting: Not displayed)
and Change settings are not displayed.
4
Operating Guide
Commercial Microwave Convection Oven
NE-SCV2
Model No.
This guide briefly describes the basic operation. Before using the product, please read the "Important
Safety Instructions" in the Operating Instructions to use the product safely.
Initial screen
How to set the Accessories
Place the rack so that it is within
the tabs of the ceramic tray.
A04203G81BP
F1017-10119
Manual Cooking
Memory Cooking
Preheat
① Use the preheating function to warm up the oven in advance.
② Preheating will resume automatically every time cooking has finished once the
preheating has been set.
Tools
(p.4)
Cooling the oven cavity
The inside of the oven can be cooled when the cavity is hot after cooking.
Oven Sheet (3 colors)
Place on the Ceramic Plate only.
Do not place on the Ribbed Plate.
Place food on the Oven Sheet.
OIt is recommended to replace it every 3
Ceramic Plate (white)
or
Place on the Wire Rack.
(Select either
Place food on the Ceramic Plate.
depending
Ribbed Plate (black)
on the food.)
Place on the Wire Rack.
Place food on the Ribbed Plate.
OBe sure to use the ribbed plate
Wire Rack
Place on the Ceramic Tray.
Ceramic Tray
Place on the Base Plate Liner.
Use as a drip tray for the food.
Base Plate Liner
Place on the bottom surface of the oven.
Use to prevent the food and oil stains.
OIt is recommended to replace it every 3
OIllustrations may differ to the actual items.
1
to 6 months depending on the stain level.
with the ribs upward and oriented
like illustration.
to 6 months depending on the stain level.