Page 2
Thank you for choosing a Kohler product. Kohler craftsmanship offers you a rare combination of proven performance and graceful sophistication that will satisfy you for years to come. The dependability and beauty of your Kohler product will surpass your highest expectations. We are very proud of our products here at Kohler and we know you will be too.
Risk of product damage or property loss. Water leakage may happen if the water pipe connector is pulled or pressed with excessive force. □ Risk of product damage. The product may be damaged if the nozzle is applied with excessive force. Kohler Co. 1369544-T01-C...
Page 4
□ This device complies with the method described in the manual. Do not use attachments not recommended by Kohler Co. such as T-valve etc. □ Do not lean on cover when use this device to prevent product from damage.
* The description of water efficiency label marked on Bidet: water efficiency label represents a compliance mark of the water efficiency grade etc. performance of Bidet. * Power value testing condition: dynamic pressure 0.2MPa, inlet water temp 15°C. Kohler Co. 1369544-T01-C...
Page 6
The antibacterial rate is more than 90%. (Perform test in accordance with GB21551.2-2010 requirements. Testing lab: China household electrical appliances testing institute; electromechanical products testing technology center of Shanghai Entry-Exit inspection and quarantine bureau.) 1369544-T01-C Kohler Co.
FRONT WASH button. It will stop automatically after 300 seconds of continuous flushing. Kohler Co. 1369544-T01-C...
Page 8
1. After deactivating seat and water temp (seat temp and water temp LED OFF), enter standby mode. Meanwhile, seat heating function deactivated to minimize energy consumption. 2. After activating seat and water temp (seat temp and water temp LED ON), exit standby mode. Meanwhile, seat heating function activated. 1369544-T01-C Kohler Co.
Page 9
16mm×8mm irradiation area. Perform test in accordance with GB /T 23131 requirements, UV radiation zone was shown in the diagram, UV working cycle activation mode refers to users guide. Testing lab: China household electrical appliances testing institute.) Kohler Co. 1369544-T01-C...
Page 10
When the unit is used for the first time, the following has been preset. Front Wash: Water Temperature: mid Seat temperature: mid Water Pressure: mid Dryer temperature: mid Position: mid Night light: on Power save: off Rear Wash: Water Temperature: mid Water Pressure: mid Position: mid 1369544-T01-C Kohler Co.
Page 11
1/3 from the front of the seat (sensor area). Proceed to the “Keypad and Panel Diagram” and “Operation” Sections to test the various seat functions. Kohler Co. 1369544-T01-C...
Care and Cleaning For best results, keep the following in mind when caring for your Kohler product: IMPORTANT! Do not immerse product in water. Test First - Always test your cleaning solution on an inconspicuous area before applying it to the entire surface.
Page 13
After having the bidet wand cleaned, press and hold the BIDET WAND button for over 2 seconds, the bidet wand will retract. Otherwise, the bidet wand will automatically retract after a while. Kohler Co. 1369544-T01-C...
Reinstall the screen. Take care to face right in position to the thread. Reconnect the water supply hose to the seat. Check all connections for leaks and make any adjustments as needed. Turn on the water supply. 1369544-T01-C Kohler Co.
Page 15
Otherwise, it may be damaged. Unload the jalousie. Pull out the original deodorization block. Replace with a new one. Load the jalousie. Make sure no impurities in the deodorization assembly before renewing the deodorization block. Kohler Co. 1369544-T01-C...
Page 16
Disconnect the water supply hose from the T-valve. Press the release button(see illustration). Slide the seat forward to disengage the seat front the mounting plate. The seat will contain water until drained. Refer to the “Drain the NOTE: water from the seat” section. 1369544-T01-C Kohler Co.
Page 17
Turn off the water supply and unplug the unit. Remove the seat from the toilet. Refer to the “Remove the Seat” section. Drain the water from the seat. Reinstall the drain plug. Kohler Co. 1369544-T01-C...
Troubleshooting This troubleshooting guide is for general aid only. A Kohler Authorized Service Representative or qualified electrician should correct all electrical problems. For warranty service, contact your dealer or wholesale distributor. General Functions Symptoms Probable Causes Recommended Action A. Power failure occurred.
Page 19
Probable Causes Recommended Action 15. The seat moves both A. Tighten the bolts of the A. The bolts for the mounting plate up and down and right mounting plate. that secure the main unit are and left. loose. Kohler Co. 1369544-T01-C...
Page 20
GB/T 26572. :Indicate only partial product series contains this substance. Note: the information provided is based on the supplier data and Kohler inspection results. The product is designed not to hurt the environment. Under current technology, all hazardous materials have been used in the smallest amounts possible.
Page 37
A. 供水阀已关。 4. 无水流。 B. 在“功能测试”部分查看 B. 落座感应器没有探测到使 激活座圈信息。 用者。 A. 查看“清洗过滤网”部 5. 冲洗水压小。 A. 过滤网阻塞。 分。 B. 提高水压到产品要求的 B. 供水水压不足。 水压范围。 6. 完成清洗前水就 A. 连续冲洗5分钟,冲洗功 A. 如需要,请再次按下冲洗 停止从喷嘴中喷 能自动停止。 按键。 出。 B. 落座感应器没有探测到使 B. 在“功能测试”部分查看 用者。 激活座圈信息。 Kohler Co. 1369544-T01-C...
Page 38
除臭功能 现象 可能原因 建议措施 13.除臭风机不工作。 A. 落座感应器没有探测到 A. 在“功能测试”部分查 看激活座圈信息。 使用者。 B. 在“使用方法”部分查 B. 误按下停止键。 看激活座圈信息。 14. 气味未消除。 A. 除臭块因使用过久而失 A. 更换除臭块。 效。 B. 某些人对气味特别敏感。 B. 无 其他 现象 可能原因 建议措施 A. 固定产品的安装板的螺 A. 拧紧安装板螺丝。 15.产品松动。 丝松动。 1369544-T01-C Kohler Co.
Need help?
Do you have a question about the K-18659T-HC-0 and is the answer not in the manual?
Questions and answers