Set Up The Receiver; Manual Setup - Harman Kardon AVR 2650 Quick Start Manual

AVR

Set Up the Receiver

Install the Batteries in the Remote Control
Remove the remote control's battery cover, insert the four supplied AAA batteries as shown in
the illustration, and replace the battery cover.
NOTE: Remove the protective plastic from the receiver's front panel so it doesn't reduce
the remote control's effectiveness.
Turn On the Receiver
1. Set the rear-panel Main Power switch to "On." (The front-panel Power indicator will
glow amber.)
2. Press the front-panel Power button.
Main Power
Switch
Configure Your Speakers
1. Plug the supplied EzSet/EQ™ microphone into the receiver's Headphone connector.
EzSet Microphone
(supplied)
8
Power
Button
Receiver
Headphone
Connector
2. Place the microphone at ear height in your listening position.
3. Turn on your TV and select the TV input where you connected the receiver in Connect
Your TV, on page 3.
4. Press the remote control's Setup button. The receiver's on-screen display (OSD) setup
menu will appear on the TV. (Note: If you have used a composite video connection to
your TV, the OSD menus will not appear on your TV. Follow the steps below using the
receiver's front-panel display.)
Source Select
Select the Source Device to Enjoy
Setup Source
Setup Source Devices Connected to the AVR
Speaker Setup
Speaker Optimization, EQ
Zone 2
Manage and Control Zone 2
System
General AVR Settings
5. Use the remote's arrow and OK buttons to select "Speaker Setup."
Speaker Setup
Automatic Setup – EzSet/EQ
Automated Speaker Setup and EQ

Manual Setup

Manually Adjust Speaker Settings
6. Select "Automatic Setup – EzSet/EQ."
7. Select "Continue."
8. Follow the instructions that appear on the screens.
Assign the Receiver's Source Buttons
1. Review the input connections you listed on the Input Connections and Assigned
Source Buttons table, on page 4. Note what changes (if any) you want to make from the
default source-button assignments that appear on the list.
2. Turn on your TV and select the TV input where you connected the receiver in Connect
Your TV, on page 3.
3. Press the remote control's Setup button. The receiver's on-screen display (OSD) setup
menu will appear on the TV. (Note: If you have used a composite video connection to
your TV, the OSD menus will not appear on your TV. Follow the steps below using the
receiver's front-panel display.)
Connections