Westward 1VW34 Operating Instructions & Parts Manual

Operating Instructions & Parts Manual
Please read and save these instructions. Read carefully before attempting to assemble, install, operate or maintain the product described. Protect yourself
and others by observing all safety information. Failure to comply with instructions could result in personal injury and/or property damage! Retain instructions
for future reference.
Westward High Reach
Supplementary Stand
Description
Westward high reach supplementary stand is designed to help prevent the tipping/
rocking of a vehicle while the vehicle is engaged on an automotive lift. Heavy gauge
steel construction and compliance with the latest ANSI/PALD standards ensure safety,
strength and stability.
Specifications
Model Capacity
1VW34 2 Ton
Figure 1 - High Reach Supplementary
Stand Components
General Safety Information
Familiarize yourself
throughly with
product, read and understand owner's
manual before use.
D not exceed rated capacity.
o
Use only on hard level surface.
Do not use the stand to support a vehicle.
Center load on saddle.
No alterations shall be made to this
product.
Failure to heed these markings may result
in severe, even fatal injury and/or property
damage.
SHI 024
Printed in China
03/10
®
Base Min.
Size Height
24" X 24" X 24" 67"
saddle
adjusting handle
Assembly
Use Figure 2 as reference.
1. Insert solenoid (#3) into main post
(#12).
2. Attach bearing (#13), adjusting handle
(#15) & saddle (#17) on solenoid.
3. Secure saddle using lock pin (#16,
punch in), and make sure it is stable.
4. Attach grease fitting nipple (#14) onto
adjusting handle.
5. Attach struts I & II (#2 & #4) to column
(#1) with bolts, washers & nuts (#9, #8
& #6). Leave nuts finger tight.
Note: Do not tighten any bolts unless
instructed to.
6. Attach support plate I & II (#5 & #7) to
column (#1) with bolts, washers & nuts
(#9, #8 & #6). Leave nuts finger tight.
7. Fully tighten strut to column and
support plate to column bolts.
8. Insert main post assembly into support
Max.
plate and secure using lock pin (#10).
Height
Operation
76"
Note: Grease prior to first use.
RAISING
Turn adjusting handle clockwise until
saddle contacts load. Continue turning
handle to raise load to required height.
LOWERING
Turn adjusting handle counter-clockwise.
main post
Maintenance
Periodically inspect each part. Ensure all
parts move freely. Apply grease to fitting
as needed. If rust appears, sand affected
area and cover with suitable utility paint.
Owner / User Responsibility
column
The owner and/or user must have an
understanding of these operating
instructions and warnings before using
strut
this auxiliary stand. Personnel involved
in the use and operation of equipment
shall be careful, competent, trained, and
qualified in the safe operation of the
equipment and its proper use when
servicing motor vehicles and their
components. Warning information should
be emphasized and understood. Owner
and/or user must study and maintain for
future reference the manufacturer's
instructions. Owner and/or user is
responsible for keeping all warning labels
and instruction manuals legible and
intact.
1VW34