Download Print this page

Thor Broadcast F-M1SDI-TR-ET Quick Setup Manual

Download this manual

https://thorbroadcast.com

800-521-8467

sales@thorfiber.com

F-M1SDI-TR-ET

Quick Setup Guide

Step 1: Connect Power

Connect the included

Power Supplies to the

TRANSMITTER and

the RECEIVER

The RUN LED will

blink indicating that

power is properly

connected

RUN LED

Step 2: Connect Fiber

Using Fiber Cable (not included)

Connect the OPT port of the TRANSMITTER

to the OPT port of the RECEIVER

NOP LED

The NOP LED indicates the status of the fiber connection. It will turn off

when the fiber is properly connected and light red when disconnected.

Need help?

Do you have a question about the F-M1SDI-TR-ET and is the answer not in the manual?

Page 1 800-521-8467 sales@thorfiber.com F-M1SDI-TR-ET Quick Setup Guide Step 1: Connect Power Connect the included Power Supplies to the TRANSMITTER and the RECEIVER The RUN LED will blink indicating that power is properly connected RUN LED Step 2: Connect Fiber Using Fiber Cable (not included)
Page 2 Step 3: Ethernet Connection (Example) Connect a computer to the TRANSMITTER using an Ethernet cable (Not included) COMPUTER TRANSMITTER FIBER RECEIVER Connect the RECEIVER to a switch/router using INTERNET an Ethernet cable (Not included) IMPORTANT: These units are Bi-Directional, therefore you may also connect ethernet devices going from the RECEIVER to the TRANSMITTER as needed.
Page 3 Rx IN = Tx OUT Step 5: RS485 Connections Example: The RS485 ports send serial data from the receiver back to the transmitter for device control. RS485 Camera RS485 Controller (Not Included) (Not Included) F-M1SDI-TR-ET Quick Setup Guide https://thorbroadcast.com 800-521-8467 sales@thorfiber.com...