Advertisement
Quick Links
F-1GPS-TX/RX
Step 1: Connect Power
OPTICAL OUTPUT
GPS
INPUT
Connect the units to their included 12V power supplies. Tighten the nut so that the connecters
are firmly attached. Power LEDs will indicate that power to the unit is properly connected.
Step 2: Connect Fiber
The Fiber Link LED on the RECIEVER will indicate that the fiber optic connection is established.
https://thorbroadcast.com
POWER
LED
Connect
Power
Supply
Connect the Optical Output
Receiver using fiber optic
connectors (Not Included)
800-521-8467
OPTICAL INPUT
GPS
OUTPUT
IMPORTANT:
of the Transmitter to the
Optical Input of the
cable with SC/APC
sales@thorfiber.com
Quick Setup Guide
FIBER LINK LED
OPT
POWER
LED
Connect
Power
Supply
Advertisement
Related Manuals for Thor Broadcast F-1GPS-TX
Summary of Contents for Thor Broadcast F-1GPS-TX
- Page 1 800-521-8467 sales@thorfiber.com F-1GPS-TX/RX Quick Setup Guide Step 1: Connect Power OPTICAL OUTPUT OPTICAL INPUT FIBER LINK LED POWER POWER Connect Connect Power Power OUTPUT INPUT Supply Supply Connect the units to their included 12V power supplies. Tighten the nut so that the connecters are firmly attached.
- Page 2 The VOLTAGE SWITCH on the TRANSMITTER, changes the voltage being sent to the antenna and can be set to 0V or 5V. VOLTAGE SWITCH Connect the GPS OUTPUT of the RECEIVER to the receiving GPS device. F-1GPS-TX/RX Quick Setup Guide https://thorbroadcast.com 800-521-8467 sales@thorfiber.com...
Need help?
Do you have a question about the F-1GPS-TX and is the answer not in the manual?
Questions and answers