Gree WK-110PA0 Owner's Manual

Digital Fan coil Thermostat Owners' Manual
Model: WK-110PA0
1. Installation instruction
1
2
Fig.1 Installation diagram for thermostat
Screw off the tapping screws ST2.9 with screwdriver, and then upwards remove main body from the
thermostat; Fit the baseboard on 86 wall box with 2 M4 screws fixing; Connect all wires according to
electrical diagram, and then put the main body on the baseboard, at last, screw down the tapping screws
ST2.9. Refer to Fig.1 for the detailed operation.
2. Electrical diagram
VALVE
YV
AC-N
POWER
AC-L
L
N AC-N
PE
Notes:
1.Some equipment has only one motor.
2.The dotted lines represent wiring which should be done
by the user.
POWER: 220V~ 50HZ.
5
4
NO. Names
1 86 wall box
2 Screw M4
3 Tapping screw ST2.9
4 Main body of thermostat
5 Baseboard of thermostat
3
4
HIGH
MID 3
LOW
2
AC-N 1
Fan coil unit
PE
Fig. 2 Wiring diagram
As shown in Fig.2, AC-L and AC-N respectively is live wire and neutral wire; HIGH, MID, LOW
respectively is one of three-step fan speed; Water valve must be installed so that indoor temperature can
be controlled by thermostat.
3. Operation instruction
(1) Appearance and structure of thermostat panel.As shown in Fig.3 :
1
2
3
4
5
(2) ON/OFF.
Dial "ON/OFF" button to "I" position, the fan coil unit will be started. Dial "ON/OFF" button to "O"
position, the fan coil unit will be stopped.
(3) Fan speed adjustment.
1) Dial fan button to
2) Dial fan button to
M1
C1
3) Dial fan button to
~
(4) Temperature setting.
1) In cooling or heating mode, press "+" or "–" button to adjust temperature. Press "+" button once, the
setting temperature will be increased by 1
PE
decreased by 1
2) In cooling or heating mode, the setting temperature is in the range of 16
M2
3) In fan mode, the setting temperature is fixed on 24
C2
~
4) Current ambient temperature will be displayed in the region for displaying temperature if there is no
operation of setting temperature. Press "+" or "–" button, the icon "
temperature will be displayed. If there is no operation on "+" or "–" button in 5s, the icon "
PE
stop flickering, and current ambient temperature will be displayed once again.
(5) Mode adjustment.
1) Every press of "M" button, the operation of mode will be changed orderly as below:
1 Mode display (cool, fan, heat)
6
Ambient temperature, setting temperature, or
2
malfunction code display
7
3 Fan speed display
4 Decrease of setting temperature
8
5 Mode button
6 Centigrade
7 Increase of setting temperature
9
8 ON/OFF dialed button
9 Dialed button of fan speed
Fig. 3 Appearance of thermostat panel
position, the fan will run at high speed.
position, the fan will run at middle speed.
position, the fan will run at low speed.
o C. Press "–" button once, the setting temperature will be
o
C.
o C and it can not be changed.
COOL FAN HEAT
Each parts of thermostat panel
o o
C~30 C.
o C" flickers and current setting
o
C" will