BEFORE USING THIS AIR CLEANER! overseas. 1. This Air Cleaner is designed for use on a flat level surface and may not work properly otherwise. ALWAYS place the • High Particulate Efficiency: The HEPAtech® filter will SOLO on a firm level surface.
The fan within the unit ensures System: Windows 2000 / XP / Vista that air is pulled into the unit and forced through the filter to Processor: Pentium 4 or better provide fresh air wherever SOLO is setup.
FILTER of the fan in the unit. Double click the slider to turn HINGES the unit on or off. Click and hold the slider to move it CARBON PRE-FILTER up and down for speed control. Once your speed is set, your SOLO unit will remember your last setting when it is turned back on.
Now that the SOLO is functional, you will need to adjust the touch controls on the product. it to direct the air flow towards you. Holding the top of the Sleep Mode ON/OFF: selecting this mode, the unit SOLO , tilt the unit back or forth until you find the angle that will shut down when your windows system goes into will provide the best comfort level.
6. Set your SOLO upright again and connect the power. 7. If the filter light on the front of the unit continues to blink, press the filter reset button on the back of the unit for 3 seconds to reset. Figure 2.
5. I need to replace the USB cable, power adapter, or CD. Installation is deemed to occur at the date of purchase. If the Air Cleaner cord or wire base fails any time within The USB cable is a standard Type 2, and may be one (1) year after installation due to a defect in material or purchased from any electronic retailer.
Air Cleaner freight prepaid. The Air Cleaner should be properly packaged to avoid damage in transit since we will not be responsible for any such damage. Proof of purchase is required when requesting warranty service. The purchaser must present sales receipt or other document that establishes proof of purchase.
Need help?
Do you have a question about the 30038 and is the answer not in the manual?
Questions and answers