Summary of Contents for Clarke Technology ALTO SPS-28
Page 1
All directions given in this book are as seen from the operator’s position at the rear of the machine. For new books write to: ALTO U.S. Inc., 2100 Highway 265, Springdale, Arkansas 72764. Form No. 70100B 11/02 CLARKE TECHNOLOGY Printed in the U.S.A.
Assembly drawing for Hopper and Optional Sidebroom Assembly ......20 Parts List ..................... 21 Assembly drawing for Battery Powered Model SPS-28B ........22 Parts List ..................... 22 Wiring Diagram ...................... 24 Parts List ..................... 25 Schematic Diagram ....................26 Page 2 CLARKE TECHNOLOGY Model SPS-28 Space Sweeper Operator's Manual...
Use of this machine to move other objects or to climb on could result in injury or damage. Do not use this machine as a step or furniture. Do not ride on this machine. CLARKE TECHNOLOGY Model SPS-28 Space Sweeper Operator's Manual Page 3...
Do not put tools or other metal objects across the battery terminals or the top of the batteries. NOTE: For best results, charge the batteries after each use. Page 4 CLARKE TECHNOLOGY Model SPS-28 Space Sweeper Operator's Manual...
56 L x 33 H x 37½ W over handle 142.2 cm x 83.8 cm x 95.3 cm Weight - Gasoline 209 lbs. (94.8 kg) Battery 339 lbs. (153.8 kg) CLARKE TECHNOLOGY Model SPS-28 Space Sweeper Operator's Manual Page 5...
Fill the gasoline tank only with regular unleaded gasoline. Use a clean container. Prevent dirt and debris from falling into the tank. Always tighten the cap on the tank. Page 6 CLARKE TECHNOLOGY Model SPS-28 Space Sweeper Operator's Manual...
4. The electronic timer stops the charger when the batteries are fully charged. See the instruction book for the charger, and for more instructions on how to use the charger and charge the batteries. CLARKE TECHNOLOGY Model SPS-28 Space Sweeper Operator's Manual Page 7...
- clockwise to raise, counterclock- Fig. 2 wise to lower. (See Fig. 2) Lower the main broom to "SWEEP" setting by placing the adjusting lever in the horizontal latched position. Page 8 CLARKE TECHNOLOGY Model SPS-28 Space Sweeper Operator's Manual...
To stop the machine, release the down pressure on the control handle. To stop the engine (Model 28G) turn stop switch OFF. To stop motor (Model 28B), turn OFF/ON switch to "OFF" position. CLARKE TECHNOLOGY Model SPS-28 Space Sweeper Operator's Manual Page 9...
NOTE: This filter is treated wuth a flame retardant chemical. The washing method of cleaning neutralizes and/or Fig. 7 eliminates this resistance to burning. Page 10 CLARKE TECHNOLOGY Model SPS-28 Space Sweeper Operator's Manual...
SPS-28 Space Sweeper (INCLUDES 28G & 28B) Section II Parts and Service Manual (70100B) CLARKE TECHNOLOGY Model SPS-28 Space Sweeper Operator's Manual Page 11...
WARNING: To prevent injury and damage, remove the batteries or gasoline before tipping the machine. Fig. 8 To get access to the grease fitting, remove the batteries and hoppers and tip the machine on its side. Page 12 CLARKE TECHNOLOGY Model SPS-28 Space Sweeper Operator's Manual...
Install the new strip and assemble the retaining screws and washers. Be sure to install the "V" of each strip in the same relation to the core as its companion strips. (See Fig. 11) CLARKE TECHNOLOGY Model SPS-28 Space Sweeper Operator's Manual Page 13...
The DC charging current should start in the "normal" range and end in the "finish" range. If the charger is still inoperative after the above checks have been made, call your nearest authorized service center. Page 14 CLARKE TECHNOLOGY Model SPS-28 Space Sweeper Operator's Manual...
Steps 5 and 7 and not in the other. Defective diode - test bulb will light up in both Steps 5 and 7. Defective Diode - Test bulb will not light up in either Steps 5 or 7. CLARKE TECHNOLOGY Model SPS-28 Space Sweeper Operator's Manual Page 15...
Filter, Dust 15724A Housing Asm., Dust Chamber 170266 Coupling 793422 Gasket, Dust Chamber NOTE: uindicates a change has taken place since 793421 Gasket, Dust Chamber Top last publication of this manual. CLARKE TECHNOLOGY Model SPS-28 Space Sweeper Operator's Manual Page 19...
Washer (Carpet Only) 902659 Bearing 63900A Guard, Caster (Carpet Only) 167308 Ring, Retaining 796922 Pulley, Side Broom Drive NOTE: uindicates a change has taken place since last publication of this manual. CLARKE TECHNOLOGY Model SPS-28 Space Sweeper Operator's Manual Page 21...
NOTES Page 26 CLARKE TECHNOLOGY Model SPS-28 Space Sweeper Operator's Manual...
Page 27
S-431 04 Molndal 2100 Highway 265 +46 31 706 73 00 Springdale, Arkansas 72764 (479) 750-1000 ALTO Norge A/S, Oslo (Norway) Bjornerudveien 24 Technical Service N-1266 1-800-356-7274 +47 2275 1770 CLARKE TECHNOLOGY Model SPS-28 Space Sweeper Operator's Manual Page 27...
Page 28
Return the card to assist Clarke in providing the performance you expect from your new floor machine. ALTO U.S. Inc., 2100 Highway 265, Springdale, Arkansas 72764. CLARKE TECHNOLOGY reserves the right to make changes or improvements to its machine without notice. Always use genuine Clarke Parts for repair.
Need help?
Do you have a question about the ALTO SPS-28 and is the answer not in the manual?
Questions and answers