Page 1
ITEM # 5111752 4-Tier Courtyard Fountain MODEL #Y95897 ALLEN + ROTH® and logo design are trademarks or Español p. XX registered trademarks of LF, LLC. All rights reserved ATTACH YOUR RECEIPT HERE Purchase Date Serial Number Questions, problems, missing parts? Before returning to your retailer, call our customer service department at 866-439-9800, 8 a.m.
SAFETY INFORMATION Please read and understand this entire manual before attempting to assemble, operate or install the product. WARNING • Save these warnings and instructions for reference. Read all instructions before use. • Failure to follow warnings and instructions may result in injury or property damage. •...
SAFETY INFORMATION (CONTINUED) GFCI DRIP LOOP NOTE: Allow the pump power cord to hang at a lower level than the wall outlet to form a “drip loop”. This will help prevent water from dripping down the power cord and getting into the wall outlet. 7.
ASSEMBLY INSTRUCTIONS 1. Connect fountain top (A) to fountain middle (B). 2. Finish the connection of fountain top (A) with fountain middle (B). Ensure the markers are aligned. 3. Connect fountain middle (B) to fountain bottom (C).
Page 7
ASSEMBLY INSTRUCTIONS (CONTINUED) 4. Finish the connection of fountain middle (B) with fountain bottom (C). Ensure the markers are aligned. 5. Open the cover (F) on the base (D). 6. Connect the fountain bottom (C) to the base (D).
Page 8
ASSEMBLY INSTRUCTIONS (CONTINUED) 7. Finish the connection of fountain bottom (C) with base (D). Ensure the markers are aligned as shown. 8. Connect the water hose with the pump (E). 9. Pull the pump (E) cable line through the base (D) and close with cover (F), then close the back cap (G).
Page 9
ASSEMBLY INSTRUCTIONS (CONTINUED) 10. Fill with water and make sure the pump (E) is submerged at least 2 inches. ≈≈≈ ≈≈≈ ≈≈≈ ≈≈≈ ≈≈≈ ≈...
OPERATING INSTRUCTIONS While the fountain is designed to operate as splash free as possible, some water splashing out of the fountain is inevitable. Place the fountain in a location where any splashing will not cause damage. Always keep the fountain working with sufficient water and clean of debris and dirt to ensure proper functioning of the pump.
Page 11
CARE AND MAINTENANCE (CONTINUED) • Check regularly that the water reservoir has sufficient water to cover the pump at all times. It will be necessary to check more frequently in warm or windy weather. • Disconnect the power and empty the reservoir if the fountain will not be used for an extended time.
TROUBLESHOOTING PROBLEM CORRECTIVE ACTION 1. Check the circuit breaker or try another outlet. If pump does 2. Check the water level in the fountain. Running the pump without not run sufficient water can damage the pump. 3. Check the setting of the flow control on the pump and adjust the flow. 4.
REPLACEMENT PARTS LIST For replacement parts, call our customer service department at 866-439-9800, 8 a.m. - 8 p.m., EST, Monday - Sunday. You could also contact us at partsplus@lowes.com. PART DESCRIPTION PART # Pump 30-07-850-B Pipe Cover 30-07-851-B Back Cap/Door 30-07-852-B Printed in China...
Page 14
MODELO #Y95897 MODEL #Y95897 ALLEN+ROTH® y el diseño del logotipo son marcas comerciales ALLEN + ROTH® and logo design are trademarks or Español p. XX o marcas registradas de LF, LLC. Todos los derechos reservados. registered trademarks of LF, LLC. All rights reserved ADJUNTE SU RECIBO AQUÍ...
Page 15
ÍNDICE Contenido del paquete......................Información de seguridad....................4 Preparación......................... 5 Instrucciones de ensamblaje o instalación................6 Instrucciones de funcionamiento..................10 Cuidado y mantenimiento....................10 Solución de problemas.......................12 Garantía..........................12 Piezas de repuesto......................13...
CONTENIDO DEL PAQUETE PIEZA DESCRIPCIÓN CANTIDAD Parte superior de la fuente Parte central de la fuente Parte inferior de la fuente Base Bomba Cubierta de la tubería Tapa posterior...
INFORMACIÓN DE SEGURIDAD Lea y comprenda completamente este manual antes de intentar ensamblar, usar o instalar el producto. ADVERTENCIA • Guarde estas advertencias e instrucciones para referencia. Lea todas las instrucciones antes del uso. • El incumplimiento de las instrucciones y advertencias podría provocar lesiones graves o daños materiales.
INFORMACIÓN DE SEGURIDAD (CONTINUACIÓN) NOTA: permita que el cable de alimentación de la bomba esté GFCI DRIP LOOP BUCLE DE GOTEO suspendido a un nivel inferior que el tomacorriente de pared para formar un “bucle de goteo”. Esto ayudará a evitar que el agua gotee en el cable de alimentación y entre al tomacorriente de pared.
INSTRUCCIONES DE ENSAMBLAJE 1. Conecte la parte superior de la fuente (A) a la parte central de esta (B). 2. Finalice la conexión de la parte superior de la fuente (A) con la parte central de esta (B). Asegúrese de que los marcadores estén alineados.
Page 20
INSTRUCCIONES DE ENSAMBLAJE (CONTINUACIÓN) 4. Finalice la conexión de la parte central de la fuente 4 (B) con la parte inferior de esta (C). Asegúrese de que los marcadores estén alineados. 5. Abra la tapa (F) de la base (D). 6.
Page 21
INSTRUCCIONES DE ENSAMBLAJE (CONTINUACIÓN) 7. Finalice la conexión de la parte inferior de la fuente (C) 7 con la base (D). Asegúrese de que los marcadores estén alineados, como se muestra. 8. Conecte la manguera de agua a la bomba (E). 9.
Page 22
INSTRUCCIONES DE ENSAMBLAJE (CONTINUACIÓN) 10. Llene con agua y asegúrese de que la bomba (E) esté sumergida al menos 5,08 cm. ≈≈≈ ≈≈≈ ≈≈≈ ≈≈≈ ≈≈≈ ≈...
INSTRUCCIONES DE FUNCIONAMIENTO Si bien la fuente está diseñada para funcionar sin salpicar agua lo más que se pueda, es inevitable que salpique algo de agua. Coloque la fuente en un lugar que no pueda sufrir daños si salpica agua. Mantenga la fuente siempre en funcionamiento con la cantidad de agua suficiente y limpia de desechos y suciedad para garantizar el funcionamiento adecuado de la bomba.
Page 24
CUIDADO Y MANTENIMIENTO (CONTINUACIÓN) • Revise regularmente que el depósito de agua tenga suficiente agua para cubrir la bomba en todo momento. Será necesaria una revisión más frecuente durante los periodos de clima cálido o ventoso. • Desconecte el suministro eléctrico y vacíe el depósito si no va a usar la fuente durante mucho tiempo.
SOLUCIÓN DE PROBLEMAS PROBLEMA ACCIÓN CORRECTIVA 1. Revise el interruptor de circuito o pruebe otro tomacorriente. Si la bomba no 2. Revise el nivel de agua en la fuente. El funcionamiento de la bomba sin funciona la cantidad de agua suficiente puede dañarla. 3.
LISTA DE PIEZAS DE REPUESTO Para obtener piezas de repuesto, llame a nuestro Departamento de Servicio al Cliente al número 866-439-9800, de lunes a domingo de 8 a.m. a 8 p.m. hora estándar del Este. Tam- bién puede ponerse en contacto con nosotros en partsplus@lowes.com. PIEZA DESCRIPCIÓN PIEZA #...
Need help?
Do you have a question about the Y95897 and is the answer not in the manual?
Questions and answers