Amcrest A3-B Flight Manual

Skylight drone

Advertisement

Quick Links

AMCREST
SKYLIGHT DRONE MODEL A3-B
FLIGHT MANUAL
Flight Time: 7 minutes
Charge Time: 90 minutes
Allow the battery to charge fully before operation.
Battery requirements for transmitter:
4 X 1.5V "AAA" size batteries (not included)
The drone is equipped with a Li-Poly rechargeable battery,
Please also pay attention to the following safety precautions:
Safety Precautions
* Do not leave the battery near a direct heat source such as fire or space heaters.
* Do not strike or throw the battery against any hard surface.
* Do not immerse the battery in water. Always store the battery in a cool dry place.
* When recharging the device, only use the battery charger intended for this product.
* Do not allow the battery to set on the charger for over 90 minutes.
* Do not operate your drone without a fully charged battery.
* Do not directly solder the battery to the device or pierce it with a nail or other sharp object.
* Do not transport or store the battery together with other metal objects.
* Never leave a charging battery unattended.
* Please read through the manual before using.
* To avoid a choking hazard, keep all small parts out of reach of small children.
* Never leave the drone unattended during battery charging.
* Never throw any batteries in a fire.
* Never fly the drone near other people.
* Keep all body parts away from the drone while the rotor blades are spinning.
Note:
* Always dispose of old batteries responsibly
* When flying outdoors make sure the drone
is set to maximum speed.
-1-

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the A3-B and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Amcrest A3-B

  • Page 1 AMCREST SKYLIGHT DRONE MODEL A3-B FLIGHT MANUAL Flight Time: 7 minutes Charge Time: 90 minutes Allow the battery to charge fully before operation. Note: * Always dispose of old batteries responsibly Battery requirements for transmitter: * When flying outdoors make sure the drone 4 X 1.5V “AAA”...
  • Page 2: Battery Protection

    * Never try to repair circuitry. No serviceable circuitry are located inside the drone or transmitter. * To avoid a choking hazard, keep all deteachable parts out of reach of small children. * The drone is very powerful when taking off. Make sure to move the throttle forward gradually to avoid it rising too quickly.
  • Page 3 Charging Insert one side of the USB connector into the drone/battery, and the other side into any computer USB port. Allow the battery to charge fully before operation. A fully charged battery will provide about 7 minutes of flight time per charge. When the green light on the battery disappears, the battery will be fully charged and ready for use.
  • Page 4: Operating Steps

    Operating Steps 3. Turn on the controller. 2. Hold the left stick/throttle 1. Place the drone onto a The power button is on the down on the controller. level surface. bottom of the controller. Continue holding until the end Release the left stick/throttle. of step 3.
  • Page 5 Trim Fine Tuning Trim is used to balance the Forward/backward drone while in flight. fine-tuning Left/right spin fine tuning Leftside/rightside fine tuning Backward Trim Backward Trimmer Forward Trim Forward Trimmer Leftside Trim Operation and Control LeftSide trimmer Rightside Trim RightSide trimmer Left spin Trim...
  • Page 6: Auto Calibration

    Radical Flips & Rolls You can perform flips and rolls with your drone in any speed setting. To perform a flip or roll with your drone push in on the right stick/rudder. You will hear a click and a beep will sound. Move the right stick/rudder in the direction you want to flip or roll. Right flip Left flip Push in on the right stick/rudder and...
  • Page 7: Headless Mode

    Headless Mode Headless mode is used to align the drone’s movements to be relative to the controller no matter which way the drone is facing. HOW TO GET ENABLE/DISABLE HEADLESS MODE? Press the button on controller(as shown in Figure A on the right) when pressed you will hear a beep sound indicating the drone is in Figure A.
  • Page 8: Fcc Compliance

    FCC Compliance This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.
  • Page 9: Ic Rss Warning

    All trademarks and registered trademarks mentioned are the properties of their respective owners. To contact Amcrest support, please do one of the following: -Visit http://amcrest.com/contacts and use the email form. -Call Amcrest Support direct using one of the following numbers:...

Table of Contents