Carlisle TRISK DEVILBISS TRUCLEAN TC-GC-11 Service Manual

Carlisle TRISK DEVILBISS TRUCLEAN TC-GC-11 Service Manual

Solvent and aqueous media gun cleaner combination

Advertisement

SERVICE MANUAL
EN
ORIGINAL LANGUAGE
Solvent and Aqueous Media Gun Cleaner Combination
TC-GC-11 (904201)
For other languages of this service manual as well as additional
product information, please scan the QR code above.
SB-81-015-R1 (11/2023)
1 / 20
www.carlisleft.com

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the TRISK DEVILBISS TRUCLEAN TC-GC-11 and is the answer not in the manual?

Questions and answers

Summary of Contents for Carlisle TRISK DEVILBISS TRUCLEAN TC-GC-11

  • Page 1 SERVICE MANUAL ORIGINAL LANGUAGE Solvent and Aqueous Media Gun Cleaner Combination TC-GC-11 (904201) For other languages of this service manual as well as additional product information, please scan the QR code above. SB-81-015-R1 (11/2023) 1 / 20 www.carlisleft.com...
  • Page 2 In this part sheet, the words WARNING, CAUTION and NOTE are used to emphasize important safety information as follows: WARNING NOTE CAUTION Hazards or unsafe practices which Hazards or unsafe practices which could result in severe personal Important installation, operation or could result in minor personal injury, injury, death or substantial property maintenance information.
  • Page 3: Purpose Of The Machine

    PURPOSE OF THE MACHINE • Do not smoke, eat or drink while close to the unit. • A fire extinguisher must always be kept nearby The unit is intended for cleaning of air-driven spray- when working with flammable solvents. Do not use guns using either thinner-based solvents or water-based water.
  • Page 4: Placing The Unit

    PERMITTED SOLVENTS • Check for local regulations concerning max allowed volume for keeping solvent in the unit. Solvent drums are not provided by Hedson Technologies, Warning! thus Hedson Technologies does not take any responsibility for the drums. Follow the solvent supplier’s •...
  • Page 5 If in any doubt, please contact the local fire service authorities for advice. Ventilation There are two different options for the unit’s ventilation: Zone 2 A) Lead the exhaust outdoors. B) Lead the metal ducting into a hood that is in turn connected to a suitable ventilation system approved for Zone 1.
  • Page 6: Preparations For Use

    PREPARATIONS FOR USE Compressed air The air is to be connected inside the unit. Front plate For removing the front plate before maintenance, lift and pull, to unhook it completely. Connecting optional accessories Female 1/4" fitting 5 bar (73 psi) The compressed air must be clean and dry according to ISO 8573-1, Class 3.4.3 or better.
  • Page 7 Hose Description Air gun (Optional accessory) Recirculating Solvent Clean Solvent Recirculating Water Clean Water Drum plugs A selection of tapered plugs are supplied to fit different drum openings. The air gun is used to dry the spray gun after the cleaning procedure.
  • Page 8 Note! Make sure that all hoses are properly led into 1. Prepare the water drums. the drum all the way down to the bottom, and that the opening is well sealed by the tapered plug. 3. Place the two drums in the cabinet on the right side.
  • Page 9 OPERATING INSTRUCTIONS AUTOMATIC WASH FOR SOLVENT BASED PAINT Item Part Funnel Air Line Cup Lid Holder Nozzle Cone 1. Empty the spray-gun of any residual paint into a Item Part separate spills-dish. Ventilation Collar 2. Place the cup and lid onto the wash compartment. Timer Button It is recommended that the spray-gun is dismantled and Front Panel...
  • Page 10 4. Fit the trigger clip: Finally, it is possible to blow out the spray-gun. Connect the spray-gun to the air line (optional), and blow out the spray-gun through the funnel under the lid. By using this funnel, you prevent the fumes from spreading within the premises.
  • Page 11 1. Make sure that the lever valve is in correct position 4. Pour the water into the filters to remove the before pressing the pedal beneath the manual wash paint from the water. compartment. Water will be fed through either the clean rinse nozzle or through the brush.
  • Page 12: Technical Data

    SERVICE TECHNICAL DATA Monthly: Manufacturer HEDSON TECHNOLOGIES AB • Clean the wash basin Hammarvägen 4 SE-232 37 Arlöv Monthly: • Remove the three nozzles in the automatic Sweden • washer and clean them with clean solvent. Tel.: +46-40- 53 42 00 Type of machine: Trisk | DeVilbiss TruClean Permitted solvents:...
  • Page 13: Troubleshooting

    TROUBLESHOOTING General Fault Cause Correction Corresponding Item/ Part Limited or no flow during Clean or replace sieve wash cycle Suction hose does not Check suction hose for leaks pick up solvent due to Limited or no flow leakage or empty solvent during wash cycle drum Spray nozzles in wash...
  • Page 14: Spare Parts

    SPARE PARTS Art. No. Name 410-2000 US 992000 Timer 410-2001 US 992001 Start Valve 410-2002 US 992002 Safety Valve 410-2003 US 992003 Pedal Hose 410-2004 US 992004 Capillary Unit (Black) www.carlisleft.com 14 / 20 SB-81-015-R1 (11/2023)
  • Page 15 410-2008 US 992008 Ventilation Nozzle 410-2006 US 992006 Pedal Assembly 410-2020 Brush GCC 410-2007 US 992007 Suction Supply Assembly 410-2011 US 992011 Sieve SB-81-015-R1 (11/2023) 15 / 20 www.carlisleft.com...
  • Page 16 410-2028 US 992028 Pedal Assembly Left GCC 410-2009 US 992009 Gunclip Accessories 410-2012 US 992012 Cone 410-2021 US 992021 Hose & Coupling for Brush GCC 410-2022 US 992022 Nozzle Assembly for Brush GCC www.carlisleft.com 16 / 20 SB-81-015-R1 (11/2023)
  • Page 17 410-2023 US 992023 Nozzle Assembly for Clean Rinse GCC 410-2024 US 992024 Suction Hose Clean Water GCC 410-2025 US 992025 Suction Hose Rec Water GCC 410-2026 US 992026 Lever Valve with Couplings GCC 410-2027 US 992027 Roller Lever Valve with Couplings GCC 410-2029 US 992029 Wash Basin GCC...
  • Page 18 410-2030 US 992030 Filter Holder GCC 410-2031 US 992031 Filtrate Box GCC 410-2013 US 992013 Side-Cup Adapter 410-2014 US 992014 Wash Bay Nozzle Pack (5) www.carlisleft.com 18 / 20 SB-81-015-R1 (11/2023)
  • Page 19 ACCESSORIES Art. No. Name 410-2010 US 992010 Air Hose Magnet Trisk 410-2033 US 992033 Blow Gun with Magnet GCC 410-2032 US 992032 Flocculation Kit GCC SB-81-015-R1 (11/2023) 19 / 20 www.carlisleft.com...
  • Page 20: Warranty Policy

    This product is covered by Carlisle Fluid Technologies’ materials and workmanship limited warranty. The use of any parts or accessories, from a source other than Carlisle Fluid Technologies, will void all warranties. Failure to reasonably follow any maintenance guidance provided may invalidate any warranty.

This manual is also suitable for:

904201

Table of Contents