Sunlite 49148-SU Installation Instructions

INSTALLATION INSTRUCTIONS
LED ROADWAY LIGHT |
CAUTION: This product uses an input 120-277V AC driver of wide range voltage, but the actual working voltage depends on the input
voltage of the photocell that is installed on the product. Normally the input voltage of the photocell is 120V/208V/240V/277V single
range, and also has 120-277V AC wide range. Please pay attention when installation.
Introduction
An internal power-factor-corrected switch-mode supply allows it to
be used from any nominal 120V-277V, 60Hz AC supply without any
variation in light output.
Installation
mounting surface with an arm.
Surface Mounting
1
First refer to the size of the diagram to drill
holes in the wall and mark them.
1 of 2
49148-SU | LFX/RL/MW/SCT/PC
49149-SU | LFX/RL/HMW/SCT/PC
Images are for illustrative purposes only. Actual fixture design is as illustrated above.
2
Attach the two bottom screws
Please read and understand this entire manual before attempting to assemble, operate or install the product.
WARNING:
To avoid a hazard to children, account for all parts and destroy all packing material. Operating temperature -40˚C to
45˚C (-40˚F to 113˚F). Suitable for outdoor/wet locations.
CAUTION:
suitable for 120-277-Volt fused circuits. Fixture must be installed according to National Electric Code and local building
DISASSEMBLE OR MAKE ALTERATIONS.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device
may not cause harmful interence, and (2) this device must accept any inteference received, including that may cause
undesired operation.
Retain these instructions for future reference.
2. 75"
Suitable for use in the following locations:
• Ambient Temp: -40~+40°C
• Wet Locations
3
Attach the fixture onto the two screws.
Attach the top screw and tighten all
screws.
Wear rubber-soled shoes and work on
14.48"
R 0. 19"