Little Giant PE-1-PCP Installation, Operation, Maintenance & Repair Parts

LITTLE GIANT WARRANTY STATEMENT
Your Little Giant product is guaranteed to be in perfect condition when it leaves our Factory. It
is warranted against defective materials and workmanship for a period of 12 months (90 day
warranty on Models: 1-AA-OM, GKPK-SC, PP-1, PPS-1, PP-12, PPS-12 , PP-230 and Cooler King)
from date of purchase by the user. No warranty on brush wear in Model 35-OM and impeller
or cam in Models PP-1, PP-12, and PP-230. Any product that should fail for either of the
above two reasons and is still within the warranty period will be repaired or replaced
returned prepaie to our Factory. All defective products returned under warranty will be fully
inspected to determine "CAUSE OF FAILURE" before any warranty is approved. Little Giant will
honor the warranty within the warranty time period specified on satisfactory written proof of
purchase.
DISCLAIMER: Any oral statements about the product made by the seller, the manufacturer, the
representatives or any other parties, do not constitute warranties, shall not be relied upon by
the user, and are not part of the contract for sale. Seller's and manufacturer's only obligation,
and buyer's only remedy, shall be the replacement and/or repair by the manufacturer of the
product as described above. Neither seller nor the manufacturer shall be liable for any injury,
loss or damage, direct, incidental or consequential (including, but not limited to, incidental or
consequential damages for lost profits, lost sales, injury to person or property, or any other
incidental or consequential loss), arising out of the use or the inability to use the product,
and the user agrees that no other remedy shall be available to it. Before using, the user
shall determine the suitability of the product for his intended use, and user assumes all risk
of liability whatsoever in connection therewith. The warranty and remedy described in this
limited warranty is an EXCLUSIVE warranty and remedy and is IN LIEU OF any other
warranty or remedy, expressed or implied, which other warranties and remedies are hereby
expressly EXCLUDED, including but not limited to any implied warranty of MERCHANTABILITY
OR FITNESS FOR A PARTICULAR PURPOSE. Some states do not allow the exclusive or
limitation of incidental or consequential damages, so the above limitation or exclusion may not
apply to you. This warranty gives you specific legal rights, and you may also have other
rights which vary from state to state.
Warranty will be VOID if any of the following conditions are found:
1. Sealed motor housing opened.
2. Product connected to voltage other than indicated on name plate.
3. Cord cut off to a length less than three feet.
4. Pump allowed to operate dry (fluid supply cut off).
5. Pump used to circulate anything other than fresh water, light oils, or other mild liquids at
approximately room temperature.
6. Product abuse by customer.
The National Electric Code requires a Ground Fault Circuit Interrupter (GFCI) be installed in the branch cir-
cuit supplying fountain equipment rated above 15 volts. Part number 599335, GFCI, is in stock and we rec-
ommend each pump be used with a GFCI.
LITTLE GIANT PUMP COMPANY
3810 NORTH TULSA STREET
OKLAHOMA CITY, OK 73112
TELEPHONE (405) 947-2511
KEEP THIS FOLDER
File this for safekeeping, It may be valuable to you for service under the terms of the warranty.
Model# __________________________________Date of Purchase ___________________________________
Catalog # ____________________________________Serial # _______________________________________
Name of Dealer ________________________________________________________________________________
Copyright 1996 Little Giant Pump Company FORM #993144 – 8/96 :
if
•
INSTALLATION
•
OPERATION
This instruction sheet will provide you with information required to safely own and operate
PE-1-PCP Series pumps. The pump you have purchased is a submersible epoxy encapsulated
pump with outer case constructed of durable polyester. The case is filled with a special heat
transfer epoxy.
This instruction sheet covers the standard models of the PE-1-PCP series. Always order
replacement parts for the specific Catalog Number of your pump. If the catalog number of
your pump is not listed in the replacement parts section, then caution should be exercised
when ordering replacement parts.
These pumps are carefully inspected, tested, and packaged to insure safe operation. When
you receive your pump, examine it carefully to determine that there are no broken or
damaged parts that may have occurred in shipment. If damage has occurred, make notation
and notify the firm from which you purchased the pump. They will assist you in the
replacement or repair of the pump.
READ INSTRUCTIONS CAREFULLY BEFORE ATTEMPTING TO INSTALL, OPERATE OR SERVICE
THE PUMP. KNOW THE PUMP APPLICATIONS, LIMITATIONS, AND POTENTIAL HAZARDS.
PROTECT YOURSELF AND OTHERS BY OBSERVING ALL SAFETY INFORMATION. FAILURE TO
COMPLY WITH INSTRUCTIONS COULD RESULT IN PERSONAL INJURY AND/OR PROPERTY
DAMAGE! RETAIN INSTRUCTIONS FOR FUTURE REFERENCE.
SMALL SUBMERSIBLE
ENCAPSULATED PUMPS
PE-1-PCP
•
•
INTRODUCTION
MAINTENANCE
REPAIR PARTS