PE-2YSA
Epoxy encapsulated, 300 GPH centrifugal pump is designed to be used in submerged parts
washer / Skimarator/ coalescer applications only. 390-09663 Nylon volute, epoxy filled polyester
and aluminium motor housing. 72" power cord no plug, with 1/2" MNPT brass conduit connector at
pump housing. 1/4" MNPT discharge. For pumping unheated metal parts cleaning solvent which is
UL classified as PJQU, as described in the Gas and Oil Equipment Directory. These refined
petroleum distillates are free from tendency to heat spontaneously; they have a closed cup flash
point no lower than 100ï½° F.
CAUTION: the low flash point of these combustible liquids does present a moderate fire hazard.
Operating the pump fully submerged offers added protection from fire risk. For other solvent
handling precautions, consult the material safety data sheet (OSHA-20 form, or equivalent), for the
solvent used.
Use only UL approved Metal Parts Cleaning Solvents. The use of fluids such as gasoline, and
lower flash point solvents is dangerous and may cause explosions of fire. Solvents other than UL
approved metal parts cleaning solvents will void the warranty of this product.
• 1/40 HP oil-filled motor
• Polyester housing
• Rated for continuous duty
• IP 68
1098 LPM @ 0.31m
Capacity:
2.53m
Shut Off:
Discharge:
12.5mm threaded
Electrical:
230V, 50Hz, 0.4A, 45 Watts
MODEL:
14940101
'Aqueous' Parts Washer Pump
AQUEOUS SOLUTIONS OR UL LISTED
SOLVENTS ONLY
(USE SUBMERSED ONLY)