Danby DAC5200DB Owner's Use And Care Manual page 13

Operating Instructions
USING THE REMOTE
CONTROLLER
BUTTONS
SLEEP OPERATION
• In this mode, the selected temperature
will increase(in cooling mode) / decrease
by 2°F 1 hour after the mode is selected.
• The temperature will then increase by
another 2°F after additional 1 hour.
• This new temperature will be maintained
for 7 hours before it returns to the
originally selected temperature. This ends
the Sleep mode and the unit will continue
1
to operate as originally programmed.
• The Sleep mode program can be
cancelled at any time during operation
by again pressing the Sleep button.
TIMER OPERATION
press the TIMER button can set the Auto-
start and Auto-stop time of the unit.
NOTE:
• To set Auto-start time, the unit must be in
the OFF position.
• To set Auto-stop time, the unit must be in
the ON postion.
To set the Auto-start time.
1. Push the TIMER button when the unit is
off, only the Auto-start feature can be set.
1
2. Keep pressing the TIMER button,each
press will increase the selected time by
0.5 hour increments,when selected time
is added to 10 hours,each press will
increase the selected time by 1 hour
increments,up to 24 hours.
3. The time can be set in a range of 0~24
hours.
4. After the desired time has established,
wait for about 10 seconds until the
setting temperature reverts back in the
display window of the air conditioner.
This indicates the program is set.
12