Danby DAC5200DB Owner's Use And Care Manual page 12

Operating Instructions
USING THE REMOTE
CONTROLLER
BUTTONS
1
3
NOTE
1. In the Auto mode, the air conditioner can logically choose the mode of
Cooling, Fan, Dehumidifying by sensing the difference between the
actual ambient room temperature and the set temperature on the
remote controller.
2. In the Auto mode, you can not switch the fan speed. It has already been
automatically controlled.
3. If the Auto mode is not comfortable for you, the desired mode can be
selected manually.
1
3
4
NOTE:
In the Fan mode, the setting temperature is not displayed in the remote
controller and you are not able to control the room temperature either. In
this case, only step 1, 2 and 4 may be performed.
1
NOTE:
In the Dehumidifying mode, you can not switch the fan speed. It has
already been automatically controlled.
11
AUTO OPERATION
Ensure the unit is plugged in and power is
available.
2
1) Press the ON/OFF button to start the air
3
conditioner.
2) Press the mode button and select
AUTO.
3) Press the TEMP
set the desired temperature. The
temperature can be set within a range of
17°C~ 30°C in 1°C increments.
COOLING /FAN OPERATION
Ensure the unit is plugged in and power is
2 available.
1) Press the ON/OFF button to start the air
3
conditioner.
2) Press the MODE button to cool.
3) Press the TEMP
set the desired temperature. The
temperature can be set within a range of
17°C~ 30°C in 1°C increments.
4) Press the FAN button to select the fan
speed in four steps-Low, Med, High,or
AUTO.
DEHUMIDIFYING OPERATION
Ensure the unit is plugged in and power is
2
available.
1) Press the ON/OFF button to start the air
conditioner.
2) Press the MODE button to select
dehumidifying.
/ button to
/ button to