Pioneer CLD-150K Operating Instructions Manual

Operating
Instructions
I acorVavankla
eG FRG EW
LASER DISC
e@ CD-ROM/CD graphic discs cannot be played with this
player.
COMPACT
DIGITAL AUDIO
CD CDV LD PLAYER
FB is: OK LaserDisc.
CLD-1810OK
The illustrations found in these Operating Instructions are
based on the CLD-150K model.
OGG GBOOO8 OOe090 Oeo88
@ PIONEER manne — CLD-ISOK
Thank you for buying this Pioneer product.
Please read through these operating instructions so you
will know how to operate your model properly. After you
have finished reading the instructions, put them away in a
safe place for future reference.
In some countries or regions, the shape of the power plug
and power outlet may sometimes differ from that shown in
the explanatory drawings. However, the method of
connecting and operating the unit is the same.
WARNING: TO PREVENT FIRE OR SHOCK HAZARD,
DO NOT EXPOSE THIS APPLIANCE TO RAIN OR
MOISTURE.
"This product complies with the Radio Interference require-
ments of the EC (European Community) Directive 87/308/EEC."
THE POWER SWITCH IS SECONDARY CONNECTED AND
THEREFORE DOES NOT SEPARATE THE UNIT FROM MAINS
POWER IN STANDBY POSITION.
LINE VOLTAGE SELECTOR SWITCH
Only multi-voltage models are provided with this
switch. U.S., Canadian, European, U.K., and Australian
models are not provided with this switch.
Mains voltages in Saudi Arabia are 127V and 220V
only. Never use this model with 110V setting in Saudi
Arabia.
The line voltage selector switch is located on the rear
panel of this player. Before your player is shipped from
the factory, the switch is set to the power requirements
of the player's destination. Check that it is set properly
before plugging the power cord into the outlet. If the
voltage is not properly set or if you move to an area
where the voltage requirements differ, adjust the selector
switch as follows:
Use a medium-sized (flat blade) screwdriver. Insert the tip
of the screwdriver into the groove of the selector switch
and turn it to set the player to the power voltage of your
area.
Set the selector so
that arrow points to
power voltage of your
area (Figure shows
arrow pointing to 220
volts.)
0) PIONEER'
The Art of Entertainment