SvoëMesto Kayfun X mini User Manual

1. Before first use
The SvoëMesto Kayfun X mini is a rebuildable atomizer inten‐
ded for use with E‐liquid. Before use, it is necessary to install a
coil. It is strongly recommended to clean the device with water,
dry it, and then lubricate all visible O‐rings with E‐liquid base or
an alternative food‐safe product.
2. Application
The SvoëMesto Kayfun X mini is designed for coils with a minimum resistance of 0.5 ohms and an electrical
power between 5 and 25 watts. It is strongly advised against using it outside the recommended parameters.
2.1 Accessing the coil deck
Step 1
If the tank is filled, turn the
atomizer upside down.
2.2 Installing a coil
CAUTION: Use only materials intended for use in electronic
cigarettes.
The coil should be placed diagonally between the coil screws
and approximately 1.5‐2mm above the air duct to ensure
uniform airflow around the coil.
Place the protruding ends of the cotton in the pockets next
to the coil, so that they stand on the liquid channels. Before
assembling the atomizer, it is recommended to put some of
the E‐liquid on the cotton.
2.2a Installing a coil using the wicking tool
Using the wicking tool enables the creation of a uniform and optimally sized coil for the atomizer. By attaching
the coil with the help of the wicking tool, it is perfectly positioned in the evaporation chamber. For detailed
instructions on using the wicking tool, please refer to our product page:
https://svoemesto.de/Verdampfer/MTL/Kayfun‐X‐Mini/
mini
Step 2
Unscrew the base counter‐
clockwise from the tank.
USER MANUAL
This user manual serves as an overview
of the functionality of the SvoëMesto
Kayfun X mini. If you have no experi‐
ence in handling rebuildable atomizers
or creating coils, please consult your
specialist dealer.
Further information and languages are
available at www.svoemesto.de.
Step 3
Remove the base to
access the coil deck.
WARNING
For your own safety, please note:
The coil must be connected with
one end to the positive pole and
the other to the negative pole.
The protruding wire ends must be
trimmed flush with the poles and
must not protrude, as this can
cause a short circuit!
The coil must not touch the coil
deck itself!