Advertisement
Quick Links
No Holes mount
Ford F-150 Lightning 2021+
425-5048
Installation Instructions
WARNING:
Do not install or use this product in any manner which would interfere with any of the vehicles
controls, air bags or safety devices. Follow vehicle owner's manual instructions should a dash
warning light come on after installation of this desk. Do not install or use this product in any
manner which causes a safety hazard for vehicle and/or occupants.
To avoid serious injury do not place this desk or any objects between the air bags and yourself
or any passengers. If necessary remove the desk before driving. Store in trunk or other safe
place.
We recommend that you do not work on the Jotto Desk while driving!
Park safely, then use. Remember, driving safely comes first.
WARNING:
Make sure of and check on a regular basis that all knobs, fastening devices and handles are tight
and secure. Repair or replace any faulty or worn parts. All equipment, such as computers, printers,
phones, etc. must be safely secured when vehicle is in motion.
DISCLAIMER:
The manufacturer of this product may not be held
liable for any accidents, injuries or problems caused
by the use or installation of this product .
Specifications subject to change without notice.
Advertisement
Related Manuals for Jotto Desk 425-5048
Summary of Contents for Jotto Desk 425-5048
- Page 1 If necessary remove the desk before driving. Store in trunk or other safe place. We recommend that you do not work on the Jotto Desk while driving! Park safely, then use. Remember, driving safely comes first. WARNING: Make sure of and check on a regular basis that all knobs, fastening devices and handles are tight and secure.
- Page 2 INSTALLATION PROCEDURE READ INSTRUCTIONS BEFORE BEGINNING INSTALLATION 1. Remove the two front OEM bolt covers / bolts from passenger side seat. Tilt back just enough to position “No Holes Mount” Base under the seat rails. 2. Replace and secure the No Holes Mount with previously removed hardware. Firmly secure and check for movement.
- Page 3 TOP ASSEMBLY & ADJUSTMENT 1. Remove Hex Head Cap Screws from stand assembly and place tube over the No-Holes Mount Base. 2. Thread (2) Hex Head Cap Screws with (2) Lock Washers through tube and into front and rear of No Holes Mount post at bottom of tube.
- Page 4 Vertical Tube Assembly 425-5052 & (2) Lock Washers 1 Tube & 1 Telescoping Rod 425-3385 425-3778 Hex Key 425-3379 JOTTO DESK ACCESSORIES Specifications subject to change without notice. Kensington® Masterlock® USB Light Pivoting Cell Phone Holder 425-1317 425-2490 425-5299 Computer securing system uses Kensington locking 12”...
Need help?
Do you have a question about the 425-5048 and is the answer not in the manual?
Questions and answers