Advertisement
Quick Links
No Holes mount
DODGE RAM ProMaster 2014-2022
425-5285
Installation Instructions
DOES NOT FIT
PROMASTER CITY
PLEASE CHECK ALL BOX FLAPS AND INSERTS FOR PARTS STORED UNDERNEATH
BEFORE DISCARDING BOX.THANK YOU.
WARNING:
Do not install or use this product in any manner which would interfere with any of the vehicles
controls, air bags or safety devices. Follow vehicle owner's manual instructions should a dash
warning light come on after installation of this desk. Do not install or use this product in any
manner which causes a safety hazard for vehicle and/or occupants.
To avoid serious injury do not place this desk or any objects between the air bags and yourself
or any passengers. If necessary remove the desk before driving. Store in trunk or other safe place.
We recommend that you do not work on the Jotto Desk while driving!
Park safely, then use. Remember, driving safely comes first.
WARNING:
Make sure of and check on a regular basis that all knobs, fastening devices and handles are tight
and secure. Repair or replace any faulty or worn parts. All equipment, such as computers, printers,
phones, etc. must be safely secured when vehicle is in motion.
DISCLAIMER:
The manufacturer of this product may not be held
liable for any accidents, injuries or problems caused
by the use or installation of this product .
Specifications subject to change without notice.
Advertisement
Related Manuals for Jotto Desk 425-5285
Summary of Contents for Jotto Desk 425-5285
- Page 1 To avoid serious injury do not place this desk or any objects between the air bags and yourself or any passengers. If necessary remove the desk before driving. Store in trunk or other safe place. We recommend that you do not work on the Jotto Desk while driving! Park safely, then use. Remember, driving safely comes first.
- Page 2 INSTALLATION PROCEDURE READ INSTRUCTIONS BEFORE BEGINNING INSTALLATION 1. Slide P/S seat completely back. Use T30 torx bit to loosen (2) upper seat bolts on top of pedestal inside seat rails. (PicA) 2. Press on seat back to tilt backwards, slide base underneath seat rails and pedestal. 3.
- Page 3 TOP ASSEMBLY & ADJUSTMENT 1. Remove Hex Head Cap Screws from stand assembly and place tube over the No-Holes Mount Base. 2. Thread (2) Hex Head Cap Screws with (2) Lock Washers through tube and into front and rear of No Holes Mount post at bottom of tube.
- Page 4 (2) Hex Head Cap Screws 425-5341 & (2) Lock Washers 425-3385 No Holes Base Hex Key 425-3769 425-3379 JOTTO DESK ACCESSORIES Specifications subject to change without notice. Kensington® Masterlock® USB Light Pivoting Cell Phone Holder 425-1317 425-2490 425-5299 Computer securing system uses Kensington locking 12”...
Need help?
Do you have a question about the 425-5285 and is the answer not in the manual?
Questions and answers