Related Manuals for HY-CLOR M Series
Summary of Contents for HY-CLOR M Series
- Page 1 M-SERIES FIBERGLASS SAND FILTERS INSTALLATION & OPERATION MANUAL Suits: HYCFGM21 HYCFGM25 HYCFGM28 Version 1.4...
-
Page 2: Table Of Contents
Always ensure the pump 5. Follow the installation and operation instructions is off. carefully to guarantee the filter’s safe operation. 6. In case of malfunction or fault, contact Hy-Clor or its authorised service agent immediately. PRODUCT HELPLINE AU: 1800 625 123 help@hyclor.com.au... -
Page 3: Carton Contents
Carton contents Item Description Multi-Port Valve (MPV) KIT Pressure Gauge Angle adjustable Union Set Backwash union Set MPV Tank O-ring Clamp Screw + Bolt Flange Clamp Filter Tank Lateral Assembly with Centre Pipe + Hub Lateral Filter Stand Drain set Sand Diverter Multiport Valve (MPV) Item... -
Page 4: Filter Specifications
Required (kg) (5 Bags) (9 Bags) (12 Bags) Max Flow Rate 192 LPM 270 LPM 320 LPM 1.5hp / Hy-Clor Pump Suitable 0.75hp 2 Speed 6 hour turn over 69,120 Lt 97,200 Lt 115,200 Lt 8 Hour Turn over 92,160 Lt... -
Page 5: How A Sand Filter Works
How a Sand Filter Works FILTER MODE BACKWASH MODE MULTIPORT VALVE MULTIPORT VALVE TO WASTE OUTLET DIRT VALVE FLUSHED OUT SAND The filter employs special filter media to eliminate glass on the backwash filter returns clear, turn the dirt particles from the pool water. This media is system off again. -
Page 6: Installation
Remove the any media in the filter will return to the pool. Contact sand diverter from Hy-Clor for assistance. the standpipe once all media has been b) Fill the filter tank with water, typically halfway up poured into the filter. -
Page 7: Installing The Multiport Valve
Note: Hy-Clor M-Series Filters come with angle adjustable unions. These allow up to body. Ensure that the a 15 degree angle allowance for UPVC pipe... -
Page 8: Maintenance
Maintenance Hy-Clor sand filters are built to last for many years, 3. Maintaining good water chemistry is essential for but proper maintenance is crucial to keep them long filtration life and cost savings. Neglecting working well. The filter media, whether it’s sand... -
Page 9: Troubleshooting
Troubleshooting Problem Possible Cause Possible Solution High pressure, low water flow at startup • Valve closed at return line after • Check and open return line MPV. valve after MPV. • Lots of dirt in sand/media • Give filter a good backwash. •... -
Page 10: Warranty Terms And Conditions
All mechanical swimming pool products supplied to consumers by Hy-Clor are to be installed or used in the Modifications to any electrical product provided by manner they are manufactured for only. - Page 11 NOTES...
Need help?
Do you have a question about the M Series and is the answer not in the manual?
Questions and answers