Advertisement
QTM-eLED+DMX
Installation Instructions
Must be installed by licensed electrician.
•
Installation must be in accordance with DMX512-A standard
•
DMX Shield must be grounded to Earth Ground at a single point external to power supply
•
LOW VOLTAGE LIGHTING SYSTEM
CLASS: 3425-15
COMPLIANT
3425-95
© 2024 QTL. All rights reserved | 155 Hill St. Milford, CT 06460 | 203-367-8777 | sales@QTL.lighting | QTL.lighting
Wear rubber shoes and work on a sturdy wooden or fiberglass ladder.
•
This power supply must be installed according to the National Electric
•
Code and local codes and ordinances.
•
This power supply is to be installed and serviced only by an licensed
•
electricians.
This power supply is to be installed so that it is not likely to be
•
contacted by people.
To avoid a hazard to children, account for all parts and destroy all
•
packaging materials.
Do not install in wet locations.
•
Specification subject to change. Rev-06-11-24
Advertisement
Table of Contents
Related Manuals for QTL QTM-eLED+DMX
Summary of Contents for QTL QTM-eLED+DMX
- Page 1 LOW VOLTAGE LIGHTING SYSTEM Do not install in wet locations. • CLASS: 3425-15 COMPLIANT 3425-95 © 2024 QTL. All rights reserved | 155 Hill St. Milford, CT 06460 | 203-367-8777 | sales@QTL.lighting | QTL.lighting Specification subject to change. Rev-06-11-24...
-
Page 2: Mounting Options
Plenum Door Required Horizontal More Units can be stacked More Units can be stacked NOTE: Rods not included. © 2024 QTL. All rights reserved | 155 Hill St. Milford, CT 06460 | 203-367-8777 | sales@QTL.lighting | QTL.lighting Specification subject to change. Rev-06-11-24... -
Page 3: Primary Wiring
Incorrect installation of the device can cause irreparable damage to the device and the connected LEDs. © 2024 QTL. All rights reserved | 155 Hill St. Milford, CT 06460 | 203-367-8777 | sales@QTL.lighting | QTL.lighting Specification subject to change. Rev-06-11-24... -
Page 4: Manual Configuration
G 1 sec B 1 sec display off W 1 sec RGBW 1 sec display off © 2024 QTL. All rights reserved | 155 Hill St. Milford, CT 06460 | 203-367-8777 | sales@QTL.lighting | QTL.lighting Specification subject to change. Rev-06-11-24... -
Page 5: Wiring Installation
To next power supply Blue Green White +24V Blue Green White +24V Blue Green White +24V © 2024 QTL. All rights reserved | 155 Hill St. Milford, CT 06460 | 203-367-8777 | sales@QTL.lighting | QTL.lighting Specification subject to change. Rev-06-11-24... - Page 6 DMX shield wire must be grounded to earth ground at a single point external to power supply. • QTM-eLED-C-US_QTL_Label_outline.pdf 1 2/26/2024 8:34:10 PM © 2024 QTL. All rights reserved | 155 Hill St. Milford, CT 06460 | 203-367-8777 | sales@QTL.lighting | QTL.lighting Specification subject to change. Rev-06-11-24...
Need help?
Do you have a question about the QTM-eLED+DMX and is the answer not in the manual?
Questions and answers