Table of Contents
Advertisement
Picture quality problems
Status
Picture is not clear
Picture is too dark
Picture is too light
www.kodak.com/go/support
Solution
■
To automatically set exposure and focus, press the Shutter button
halfway. When the framing marks turn green, press the Shutter
button completely down to take the picture.
■
Clean the lens (see
■
Make sure the camera is not in Macro mode if you are more than
27.6 in. (70 cm) from your subject.
■
Place the camera on a flat, steady surface or use a tripod (especially
in high-zoom settings or in low light).
■
Reposition the camera for more available light.
■
Use Fill flash (see
behind the subject.
■
Move so that the distance between you and the subject is within the
effective flash range. (See camera specifications starting on
page
44.)
■
To automatically set exposure and focus, press the Shutter button
halfway. When the framing marks turn green, press the Shutter
button completely down to take the picture.
■
In Smart Capture mode, adjust the Exposure Compensation
page
24).
■
Reposition the camera to reduce the amount of available light.
■
Turn the flash off (see
■
Move so that the distance between you and the subject is within the
effective flash range. (See camera specifications starting on
page
44.)
■
To automatically set exposure and focus, press the Shutter button
halfway. When the framing marks turn green, press the Shutter
button completely down to take the picture.
■
In Smart Capture mode, adjust the Exposure Compensation
page
24).
page
46).
page
7) or change your position so light is not
page
7).
Getting help
(see
(see
41
Advertisement
Table of Contents
