Table of Contents
Advertisement
1. High Definition Audio supports Jack Sensing, but the panel wire on
the chassis must support HDA to function correctly. Please follow the
instruction in our manual and chassis manual to install your system.
2. If you use AC'97 audio panel, please install it to the front panel audio
header as below:
A. Connect Mic_IN (MIC) to MIC2_L.
B. Connect Audio_R (RIN) to OUT2_R and Audio_L (LIN) to OUT2_L.
C. Connect Ground (GND) to Ground (GND).
D. MIC_RET and OUT_RET are for HD audio panel only. You don't
need to connect them for AC'97 audio panel.
E. Enter BIOS Setup Utility. Enter Advanced Settings, and then select
Chipset Configuration. Set the Front Panel Control option from
[Auto] to [Enabled].
F. Enter Windows system. Click the icon on the lower right hand
taskbar to enter Realtek HD Audio Manager.
For Windows
Click "Audio I/O", select "Connector Settings"
"Disable front panel jack detection", and save the change by
clicking "OK".
For Windows
Click the right-top "Folder" icon
panel jack detection", and save the change by clicking "OK".
System Panel Header
(9-pin PANEL1)
(see p.10 No. 14)
Chassis Speaker Header
(4-pin SPEAKER 1)
(see p.10 No. 16)
Chassis Fan Connector
(3-pin CHA_FAN1)
(see p.10 No. 17)
CPU Fan Connector
(4-pin CPU_FAN1)
(see p.10 No. 4)
FAN_SPEED_CONTROL
2000 / XP / XP 64-bit OS:
®
Vista
/ Vista
64-bit OS:
®
TM
TM
, choose "Disable front
This header accommodates
PLED+
PLED-
PWRBTN#
several system front panel
GND
functions.
1
DUMMY
RESET#
GND
HDLED-
HDLED+
Please connect the chassis
1
SPEAKER
speaker to this header.
DUMMY
DUMMY
+5V
Please connect a chassis fan
cable to this connector and
GND
match the black wire to the
+12V
CHA_FAN_SPEED
ground pin.
Please connect a CPU fan cable
4 3 2 1
to this connector and match
the black wire to the ground pin.
GND
+12V
CPU_FAN_SPEED
, choose
2 3
2 3
2 3
2 3
2 3
Advertisement
Table of Contents
