Page 21
ENGLISH S5085/06, S5075/06 S5075_5085_EN_A6_CS6.indd 20 15/05/19 12:2...
Page 22
ENGLISH Introduction Congratulations on your purchase and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.philips. com/welcome. General description (Fig. 1) Click-on trimmer attachment Protection cap for shaving unit Click-on shaving unit...
Page 23
- If your shaver comes with a cleaning system, always use the original Philips cleaning fluid (cartridge or bottle, depending on the type of cleaning system).
Page 24
This is normal and not dangerous because all electronics are enclosed in a sealed power unit inside the shaver. Electromagnetic fields (EMF) - This Philips appliance complies with all applicable standards and regulations regarding exposure to electromagnetic fields. General - This shaver is waterproof.
Page 25
ENGLISH the appliance is charging, the battery charge indicator flashes slowly. Battery fully charged Note: This appliance can only be used without cord. Note: When the battery is full, the display switches off automatically after 30 minutes. If you press the on/off button during charging, the ‘unplug for use’...
Page 26
ENGLISH Activating the travel lock Press the on/off button for 3 seconds to enter the travel lock mode. 3 sec. - While you activate the travel lock, the travel lock symbol lights up continuously. When the travel lock is activated, the travel lock symbol flashes. Deactivating the travel lock Press the on/off button for 3 seconds.
Page 27
ENGLISH Charging with the adapter Insert the small plug into the appliance and put the adapter in the wall socket. Using the shaver Switching the appliance on and off To switch on the appliance, press the on/off button once. To switch off the appliance, press the on/off button once.
Page 28
ENGLISH Move the shaving heads over your skin in circular movements. Note: Do not make straight movements. Clean the shaver after use (see chapter ‘Cleaning and maintenance’). Wet shaving You can also use this shaver in the shower or on a wet face with shaving foam or shaving gel.
Page 29
ENGLISH Dry your face and thoroughly clean the shaver after use (see chapter ‘Cleaning and maintenance’). Note: Make sure you rinse all foam or shaving gel off the shaver. Using the click-on attachments Removing or attaching the click-on attachments Make sure the appliance is switched off. Pull the attachment straight off the appliance.
Page 30
ENGLISH You can now start trimming. Clean the attachment after use (see chapter ‘Cleaning and maintenance’). Cleaning and maintenance Cleaning the shaver under the tap Clean the shaver after every shave for optimal shaving performance. Be careful with hot water. Always check if the water is not too hot, to prevent your hands from getting burnt.
Page 31
ENGLISH Thorough cleaning method Make sure the appliance is switched off. Press the release button and open the shaving unit. Pull the shaving head holder off the bottom part of the shaving unit. Turn the retaining rings anticlockwise and remove them. Remove the shaving heads from the shaving head holder.
Page 32
ENGLISH After cleaning, place the cutter back into the guard. Put the shaving heads back into the shaving head holder. Note: Make sure the projections of the shaving heads fit exactly into the recesses of the shaving-head holder. Place the retaining rings back onto the shaving head holder and turn them clockwise.
Page 33
ENGLISH - Turn the ring clockwise until your hear ‘click’ and the ring is fixed. Note: Hold the shaving head holder in your hand when you reinsert the shaving heads and reattach the retaining rings. Do not place the shaving head holder on a surface when you do this, as this may cause damage.
Page 34
For maximum shaving performance, we advise you to replace the shaving heads every two years. Replace damaged shaving heads immediately. Only replace the shaving heads with original Philips shaving heads as specified in chapter ‘Ordering accessories’. Press the release button and open the shaving unit.
Page 35
ENGLISH Turn the retaining rings anticlockwise and remove them. Remove the shavings heads from the shaving head holder and throw them away. Place new shaving heads in the holder. Note: Make sure the projections of the shaving heads fit exactly into the recesses of the shaving head holder. Place the retaining rings back onto the shaving heads and turn them clockwise.
Page 36
(‘click’). Ordering accessories To buy accessories or spare parts, visit www. shop.philips.com/service or go to your Philips dealer. You can also contact the Philips Consumer Care Centre in your country (see the worldwide guarantee leaflet for contact details). S5075_5085_EN_A6_CS6.indd 35...
Page 37
Shaving heads - We advise you to replace your shaving heads every two years. Always replace the shaving heads with original SH50/51 Philips shaving heads. Recycling Do not throw away the appliance with the normal household waste at the end of its life, but hand it in at an official collection point for recycling.
Page 38
Take out the battery holder and cut the battery tags with a pair of cutting pliers. Guarantee and support If you need information or support, please visit www.philips.com/support or read the separate worldwide guarantee leaflet. Guarantee restrictions The shaving heads (cutters and guards) are not covered by the terms of the international guarantee because they are subject to wear.
ENGLISH Problem Possible cause Solution The shaver does The shaving heads Replace the shaving heads not shave as well are damaged or (see chapter ‘Replacement’). as it used to. worn. Hairs or dirt Clean the shaving heads by obstruct the following the steps of the shaving heads.
Need help?
Do you have a question about the S5075/06 and is the answer not in the manual?
Questions and answers