Table of Contents
Advertisement
Step 3.
Firmly insert the DIMM into the slot until the retaining clip snap back in place
and the DIMM is properly seated.
2.6 Expansion Slots (PCI and AGP Slots)
2.6 Expansion Slots (PCI and AGP Slots)
2.6 Expansion Slots (PCI and AGP Slots)
2.6 Expansion Slots (PCI and AGP Slots)
2.6 Expansion Slots (PCI and AGP Slots)
There are 6 PCI slots and 1 AGP slot on both PE Pro and GE Pro motherboards.
PCI slots:
AGP slot:
Installing an expansion card
Installing an expansion card
Installing an expansion card
Installing an expansion card
Installing an expansion card
Step 1.
Before installing the expansion card, read the documentation of the
expansion card and make necessary hardware settings for the card.
Step 2.
Remove the system unit cover (if your motherboard is already installed in a
chassis).
Step 3.
Remove the bracket facing the slot that you intend to use. Keep the screw
for later use.
Step 4.
Align the card connector with the slot and press firmly until the card is
completely seated on the slot.
Step 5.
Fasten the card to the chassis with screws.
Step 6.
Replace the system cover.
2.7 Jumpers Setup
2.7 Jumpers Setup
2.7 Jumpers Setup
2.7 Jumpers Setup
2.7 Jumpers Setup
The illustration shows how jumpers are setup.
When the jumper cap is placed on pins, the jumper
is "SHORT". If no jumper cap is placed on pins,
the jumper is "OPEN". The illustration shows a
3-pin jumper whose pin1 and pin2 are "SHORT"
when jumper cap is placed on these 2 pins.
1 2
1 2
1 2
1 2
1 2
PCI slots are used to install expansion cards that have the 32-bit PCI
interface.
The AGP slot is used to install a graphics card.
The ASRock AGP slot has a special locking mechanism which
can securely fasten the graphics card inserted.
Advertisement
Table of Contents
