Onboard Headers And Connectors - ASROCK P45TS Installation Manual

If you want to overclock the CPU you adopt to FSB1066 on this motherboard, you need
to adjust the jumpers. Please short pin4, pin5 for FSB2 jumper and pin4, pin5 for FSB3
jumper. Otherwise, the CPU may not work properly on this motherboard. Please refer to
below jumper settings.
If you want to overclock the CPU you adopt to FSB1333 on this motherboard, you need
to adjust the jumpers. Please short pin3, pin4 for FSB2 jumper and pin4, pin5 for FSB3
jumper. Otherwise, the CPU may not work properly on this motherboard. Please refer to
below jumper settings.
If you want to overclock the CPU you adopt to FSB1600 on this motherboard, you need
to adjust the jumpers. Please short pin3, pin4 for FSB2 jumper and pin3, pin4 for FSB3
jumper. Otherwise, the CPU may not work properly on this motherboard. Please refer to
below jumper settings.

2.6 Onboard Headers and Connectors

2.6 Onboard Headers and Connectors
2.6 Onboard Headers and Connectors 2.6 Onboard Headers and Connectors 2.6 Onboard Headers and Connectors
Onboard headers and connectors are NOT jumpers. Do NOT place
jumper caps over these headers and connectors. Placing jumper
caps over the headers and connectors will cause permanent dam-
age of the motherboard!
FDD connector
(33-pin FLOPPY1)
(see p.2 No. 25 or p.3 No. 24)
Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the
connector.
ASRock P45TS-R / P45TS Motherboard
the red-striped side to
Pin1
1 9 1 9 1 9
1 9 1 9