Onboard Headers And Connectors - ASROCK P43DE3L User Manual

2.8 Onboard Headers and Connectors

2.8 Onboard Headers and Connectors 2.8 Onboard Headers and Connectors
2.8 Onboard Headers and Connectors 2.8 Onboard Headers and Connectors
Onboard headers and connectors are NOT jumpers. Do NOT place
jumper caps over these headers and connectors. Placing jumper
caps over the headers and connectors will cause permanent dam-
age of the motherboard!
Primary IDE connector (Blue)
(39-pin IDE1, see p.10 No. 9)
connect the blue end
to the motherboard
80-conductor ATA 66/100/133 cable
Note: Please refer to the instruction of your IDE device vendor for the details.
Serial ATAII Connectors
(SATAII_1 (Port 0):
see p.10, No. 13)
(SATAII_2 (Port 1):
see p.10, No. 14)
SATAII_5 (Port 4)
(SATAII_3 (Port 2):
see p.10, No. 15)
(SATAII_4 (Port 3):
see p.10, No. 16)
SATAII_6 (Port 5)
(SATAII_5 (Port 4):
see p.10, No. 18)
(SATAII_6 (Port 5):
see p.10, No. 19)
Serial ATA (SATA)
Data Cable
(Optional)
USB 2.0 Headers
(9-pin USB6_7)
(see p.10 No. 21)
(9-pin USB8_9)
(see p.10 No. 17)
IDE1
PIN1
These six Serial ATAII (SATAII)
connectors support SATA data
SATAII_1 (Port 0)
cables for internal storage
devices. The current SATAII
SATAII_2 (Port 1)
interface allows up to 3.0 Gb/s
data transfer rate.
SATAII_3 (Port 2)
SATAII_4 (Port 3)
Either end of the SATA data cable
can be connected to the SATA /
SATAII hard disk or the SATAII
connector on this motherboard.
USB_PWR
Besides six default USB 2.0
P-7
P+7
GND
ports on the I/O panel, there are
DUMMY
two USB 2.0 headers on this
1
motherboard. Each USB 2.0
GND
P+6
header can support two USB
P-6
USB_PWR
2.0 ports.
USB_PWR
P-9
P+9
GND
DUMMY
1
GND
P+8
P-8
USB_PWR
1 9 1 9 1 9
1 9 1 9
connect the black end
to the IDE devices