Advertisement
Quick Links
Advertisement
Related Manuals for Schiit KRAKEN
Summary of Contents for Schiit KRAKEN
- Page 1 5 C H A N N E L P O W E R A M P L I F I E R...
- Page 2 3. Assure adequate ventilation, do not block any ventilation Kraken is designed to deliver amazing openings, or place near heat sources. performance—for years to come. 4. Use only the supplied power cord or suitable replacement.
- Page 3 115VAC 250W 1 Connect your speakers. You can connect 4 Turn on when it’s time to listen. Right is up to 5 speakers to Kraken. Using banana on. Left is off. Pretty simple. Feel free to plugs makes it much easier! leave the amp on all the time if you’d like.
- Page 4 2 When these LEDs are all lit, you’re good to go. This means normal operation. The *Kraken takes about 30 seconds to perform self- checks when first turned on. When coming out of LEDs will “scan” back and forth (yes, like Standby mode, it takes about 60 seconds.
- Page 5 Okay, so you have a flashing light. Deep 2. Over-current. One or more LEDs flash to breath. We’ll get this taken care of shortly. indicate the affected channel or channels. If the amp is connected to very low-impedance When the amp’s front lights flash during speakers (3 ohms or lower), playing very operation (and the amp mutes), or if it never loud music can cause an over-current...
- Page 6 The amp keeps going into over-current the problem. protection. It’s pretty hard to get Kraken into I hear hum. over-current protection, but it might hit it if Ensure you are using good, well-shielded you’re using very low-impedance speakers.
- Page 7 Schiit Audio warrants to the original purchaser that this product shall be free from defects in material and workmanship for five (5) years from the date of purchase. If a defect covered by this warranty occurs during this period, Schiit Audio will repair the defective product, free of charge.
- Page 8 (1) Power Cord (0) Class D modules (0) Switching supplies (Various) Stickers and stuff (Infinite) Appreciation from the whole Schiit crew in Valencia, CA and Corpus Christi, TX (Even more) Thanks from our chassis and PCB guys in California, Nevada, and Utah.
Need help?
Do you have a question about the KRAKEN and is the answer not in the manual?
Questions and answers