1. Manuals
  2. Brands
  3. Gladen Manuals
  4. Car Amplifier
  5. XS 75c6
  6. User manual

Gladen XS 75c6 User Manual

Hide thumbs
1
2
3
4
5
6
7
8

Advertisement

Table of Contents

User s Guide
for amplifiers
XS 75c6

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the XS 75c6 and is the answer not in the manual?

Questions and answers

Related Manuals for Gladen XS 75c6

Summary of Contents for Gladen XS 75c6

  • Page 1 User s Guide for amplifiers XS 75c6...
  • Page 2 FEATURES XS 75c6 6-Channel high power class-AB amplifier Full MOS-FET power supply Stable into 2 ohm stereo per channel and 4 ohm bridged mode Variable switchable Low Pass Filter from 2K to 6K Hz(CH3/4), 50 to 300 Hz(CH5/6) Variable switchable High Pass Filter from 50 to 150Hz or 2 KHz to 6 KHz...

  • Page 3: Power Connection

    POWER CONNECTION XS 75c6 +12V Battery disconnection First, disconnect the power supply of the vehicle by removing the ground cable of the battery. Ground connection Connect the GND (ground) connection of the amplifier with the car chassis. Keep this cable as short as possible (not longer than 50 cm) and use a suitable cross section (AWG size 6 - 4).

  • Page 4: Rca Connection

    RCA CONNECTION XS 75c6 BRIDGE BRIDGE Channel 3 / 4 REMOTE CH6/R CH5/L +12V 3 x 30A CH4/R CH3/L CH6/R CH4/R CH2/R Power CH1~4 GAIN HERTZ HERTZ HERTZ HERTZ GAIN CH5~6 0.2V Protection 0.2V INPUT MODE SUBSONIC/HPF 2-IN HERTZ GAIN 4.4K...

  • Page 5: Speaker Connection

    SPEAKER CONNECTION XS 75c6 6-Channel Stereo Speaker- impedance 2 ~ 8 ohm Speaker- impedance 1 ~ 8 ohm 4-Channel Stereo + 1-Channel Mono Bridged Speaker- impedance 2 ~ 8 ohm CH5/6-MONO SUBWOOFER Speaker- impedance 2 ~ 4 ohm...
  • Page 6 SPEAKER CONNECTION XS 75c6 6-Channel Full Active MIDRANGE Speaker- impedance 2 ~ 8 ohm ATTENTION TWEETER Push "x40" and ON Speaker- impedance KICK WOOFER 1 ~ 8 ohm 4-Channel Active + Mono Bridged MIDRANGE Speaker- impedance 2 ~ 8 ohm...

  • Page 7: Specifications

    SPECIFICATIONS XS 75c6 Rated Power output -RMS power, 4 ohms stereo 4x 70 W + 2x 100 W -RMS power, 2 ohms stereo 4x 90 W + 2x 190 W -RMS power, 4 ohms bridged 2x 180 W + 1x 380 W...

  • Page 8: Troubleshooting

    TROUBLESHOOTING This power amplifier features an efficient protection system to prevent damages due to overheating, overvoltage, short-circuit and DC at the loudspeaker output. If there is an error or problem, the protection LED will light up red. To check the problem, first turn down all levels of the head unit and then turn it off. AMPLIFIER DOESN'T - check condition of ground connection POWER UP / LED DOESN'T...

Table of Contents