Gladen SPL 5000c1 LV User Manual

Advertisement

User s Guide
for amplifiers
L V
SPL 5000c1
SPL 5000c1 HV
Manual size : 150 x 210mm

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SPL 5000c1 LV and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Gladen SPL 5000c1 LV

  • Page 1 User s Guide for amplifiers SPL 5000c1 SPL 5000c1 HV Manual size : 150 x 210mm...
  • Page 2: Installation

    + 12V source. This may be a toggle switch, a relay, the source unit's remote ouput cable or power antenna trigger cable. Connect the remote turn on cable to the power terminal labeled as REM. GLADEN Europe GmbH Bertha-Benz-Str. 9 D-72141 Walddorfhäslach...
  • Page 3: Panel Layout

    Panel Layout (Model : SPL 5000c1 LV / SPL 5000c1 HV) BASS REMOTE Power GAIN SUBSONIC BOOST FREQ. PHASE MASTER SPEAKER OUTPUT Protect 10Hz 60Hz 12dB 30Hz 90Hz 30Hz 250Hz SLAVE MASTER SLAVE INPUT OUTPUT INPUT 1) INPUT Connect preamp signal cables from head unit to RCA input of amplifier.
  • Page 4 +12V (B+), GND, REM (Model : SPL 5000c1 LV / SPL 5000c1 HV) Caution This amplifier is not supplied with internal fuse in itself. Make POWER POWER sure you install in-line fuse holder from terminal of battery. GND (GROUND CONNECTION) For connection to chassis ground.
  • Page 5: Single Connection

    +12V ), GND, REM Connection (Model : SPL 5000c1 LV / SPL 5000c1 HV) GROUND SINGLE CONNECTION * Keep ground as short as possible, no longer than 20” (50 cm). Caution This amplifier is not supplied with internal fuse in itself. Make...
  • Page 6: Speaker Connection

    Speaker Connection (Model : SPL 5000c1 LV / SPL 5000c1 HV) SINGLE CONNECTION BASS REMOTE Power GAIN SUBSONIC BOOST FREQ. PHASE MASTER SPEAKER OUTPUT Protect 10Hz 60Hz 12dB 30Hz 90Hz 30Hz 250Hz SLAVE MASTER SLAVE INPUT OUTPUT INPUT HEAD UNIT...
  • Page 7: Troubleshooting

    Troubleshooting Assure that the Power LED is on, if so please proceed with step # 3, if not, continue with the steps below; 1. Check the in line fuse (s) on the battery’s positive cable, and replace if needed. 2. Assure that the Ground is properly attached to the vehicle chassis on a clean metal point, tighten or grind the connection point once again.
  • Page 8: Specifications

    Specifications MODEL CODE SPL 5000c1 LV SPL 5000c1 LV, as the letters LV (low voltage) implies, is an 14.4V optimized amplifier Continuous power output @14.4V Input -RMS power, 4 ohms mono : 1350W x 1CH -RMS power, 2 ohms mono...

This manual is also suitable for:

Spl 5000c1 hv

Table of Contents