Table of Contents
Advertisement
3.1 BIOS Setup Utility
This section explains how to configure your system using the BIOS Setup Utility.
The Flash Memory on the motherboard stores the BIOS Setup Utility. When you
start up the computer, there is a chance for you to run the BIOS Setup. Press
<F2> during the Power-On-Self-Test (POST) to enter the BIOS Setup Utility,
otherwise, POST continues with its test routines.
If you wish to enter the BIOS Setup after POST, restart the system by pressing
<Ctl> + <Alt> + <Delete>, or by pressing the reset button on the system chassis.
You can also restart by turning the system off and then back on.
Because the BIOS software is constantly being updated, the
following BIOS setup screens and descriptions are for refer
ence purpose only, and may not exactly match what you see
on your screen.
3.2 BIOS Setup Utility Main Menu
When you enter the BIOS Setup utility, the following screen appears:
F1: Help
F1: Help
Esc: Exit
Esc: Exit
Set Time, Date, Hard Disk Type . . .
The main menu of the Setup Utility displays a list of the options that are available.
The highlighted item is currently selected. Use
highlight bar to select items, then press <Enter> to make configuration for a
specific item.
Chapter 3 BIOS Setup
AMIBIOS SETUP UTILITY - VERSION 3.31a
M266 (A) BIOS P1.50
Standard CMOS Setup
Advanced CMOS Setup
Advanced Chipset Setup
Power Management Setup
PCI / Plug and Play Setup
Peripheral Setup
Hardware Monitor Setup
Change Supervisor Password
Change User Password
Auto Configuration with Optimal Settings
Save Savings and Exit
Exit Without Saving
: Select Item
+/-: Change Values
: Select Menu
Enter: Select
F9: Setup Defaults
Sub-Menu
F10: Save & Exit
arrow keys to move the
Advertisement
Table of Contents
