RailFX Professional 224 Series Installation Instructions Manual

Professional 224 Series Installation Instructions
for Wood or Metal Posts on Level Runs
Tools Required for Installation
• 5/32" Drill Bit
• 1/4" Drill Bit
• 29/64" Drill Bit
• 1/8" Hex Wrench
• 3/16" Hex Wrench
Cut-off Tool
Used to cut cable flush with the end of the
Pull-Lock fittings, and to cut excess threads
®
off stud-type Receivers. Includes mandrel
and two cut-off wheels.
Order RFX-CUT-OFF KIT
A: Drill Posts
Wood posts must be a minimum 4"x4".
Hole size for 1/8" dia. cable installation
29/64"
2-1/2" minimum
dia.
outside of
post
5/32"
dia.
5/32"
dia.
Metal end posts are drilled through, using a 29/64" drill bit for
Receiver and Pull-Lock
Hole sizes through intermediate posts and/or cable braces are:
5/32" for 1/8" cable
7/32" for 3/16" cable
All holes should be burr-free.
RFX-224-KITINST | 1.1.20
• 3" Combo Wrench
• RFXPL-KEY
• Cable Gripper
• Cut Off Kit (mandrel)
• Cut Off Kit (wheel)
5/32"
dia.
29/64"
2-3/8" minimum
dia.
outside of
post
5/32"
dia.
fitting.
®
Pre-attached
swaging stud
Invisiware ®
Receiver
NOTE: Parts must be kept clean and free of debris before
installation for best results.
Hole size for 3/16" dia. cable installation
For End Post
29/64"
using a
dia.
Receiver
outside of
and stud
post
For End Posts
7/32"
using
dia.
Pull-Lock
®
fitting
For Intermediate
7/32"
Post
dia.
passing cable only
P: 206.453.1123 | F: 866.802.1690 | railfx.net
1/8" and 3/16"
1x19 stainless
steel cable
Delrin ® washers for
use with metal posts
Stainless Steel washers for
use with wood posts
224 Series
2-1/2" minimum
2-3/8" minimum
2.375"
Pull-Lock ®
Fitting
with cap
7/32"
dia.
29/64"
dia.
outside of
post
7/32"
dia.
29/64"