Page 1
P: 206.453.1123 | F: 866.802.1690 | railfx.net Kit 300-C Series Installation Instructions for Wood Posts with Composite Sleeves with an Outside Diameter Greater than 4-1/2" Tools Required for Installation • 5/32" Drill Bit • 3" Combo Wrench 1/8” or 3/16”...
Page 2
P: 206.453.1123 | F: 866.802.1690 | railfx.net B. Install Tensioning Terminal Install the Adjust-A-Body ® with Hanger Bolt by driving the hanger bolt / lag end into the pre-drilled hole in your end post using a 5/32" hex wrench in the hex-broached end of the hanger bolt (if applicable) or a 1/4"...
Page 3
P: 206.453.1123 | F: 866.802.1690 | railfx.net D. Feed/Crimp Cable through Corner Posts As composite sleeves can be somewhat fragile, it is recommended to stop and start at corners. Do not allow a cable to exit a post on an angle; it can damage the sleeve.
Page 4
P: 206.453.1123 | F: 866.802.1690 | railfx.net F. Tension Cables Tension the cable by holding it with cable gripping pliers or the RFX Small Cable Gripper and vice grips to prevent the cable from turning while you turn the Adjust-A-Body ®...