AES E-LOOP Manual

Specifications
Model E-LOOP: EL00IG & EL00IG-RAD
Frequency: 433.39 MHz.
Security: 128-bit AES encryption.
Range: up to 50 metres.
Battery life: up to 6-10 years.
Battery type: 14500 mA battery.
Transmitting power: <10mW.
Wireless Vehicle Detection System
Installation in 3 simple steps
STEP 1:
Coding e-LOOP into e-Trans 50
Coding e-LOOP without magnet
1. Power up the e-TRANS-50 and hold the e-Loop
within 10cm of the transceiver's antenna.
2. Now press and release the CODE button on the
e-Trans 50. The yellow and red LEDs will flash on
the e-Loop, and the blue LED on the e-TRANS-50
will flash 3 times. The systems are now paired.
NOTE: For coding e-TRANS-200 LCD transceivers, refer
to e-TRANS-200 manual.
Coding e-LOOP with magnet
1. Power up the e-TRANS-50, then press and release the
CODE button. The blue LED on the e-TRANS-50 will
light up.
2. Now place the magnet on the CODE recess on the e-
Loop – the yellow LED will flash 3 times, and the blue
LED on the e-Trans 50 will flash 3 times. The systems
are now paired and you can remove the magnet.
E. sales@aesglobalonline.com
T: +44 (0) 288 639 0 693
www.aesglobalonline.com
MAGNET
Safety instructions
Before proceeding with the product's
installation, check that all the materials are
in good working order and suited to the
intended applications.
Warning! – Exhausted batteries contain
polluting substances; therefore they may not
be disposed of together with unsorted
household waste. They must be disposed of
separately according to the regulations
locally in force.
Installation Warnings
The e-LOOP should be installed in a location
that is always visible. Do not place the e-
LOOP in a dip or area where snow or water
can sit. Keep e-LOOP central in the driveway
so as it passes directly underneath the
vehicles.
DISCLAIMER: UNITS WITH THE PRESENCE
FEATURE IS NOT TO BE USED AS A SOLE SAFETY
DEVICE & SHOULD BE USED IN CONJUNCTION
WITH STANDARD GATE SAFETY PRACTICES.
Document updated: 30/08/23.
PLACING MAGNET INTO
BUTTON RECESS.