Demco CalmScape W13856590 Assembly Instructions

CalmScape Wall Mount Assembly Instructions
Included for acoustic assembly:
Impaler clips
Installation materials for drywall
Impaler clip instructions:
1. Place the panel on the wall where you would like it to go. Lightly mark the location of the panel's exterior edges on the wall.
2. Mount the included impaler clips on the wall with the nail side pointing up, positioning the hole of each clip six inches in and
down from the marks you made in step one. Screw each clip into the wall and use anchors if studs aren't present.
3. Place the panel over the impaling clips so the panel is in the same position as it was in step one. Press the panel firmly against
the wall and down at the same time.
4. Use a level on the top of the panel and straighten the panel if needed.
5. Optional: For added strength, you can add construction adhesive to the impaler clips.
See impaler clip diagrams below:
Questions? Contact Demco Customer Service at custserv@demco.com
or 800.962.4463 (Monday–Friday, 8 a.m.–4:30 p.m. CT).
Needed for acoustic assembly:
Screwdriver or drill
Installation materials for anything other than drywall
Construction adhesive (optional)
www.demco.com