Kodiak K-PLASMATSK-6 Operating Instructions

24730 - K-PLASMATSK-6/12 Operating Instructions and Precautions 04222201
Charging: This product is rechargeable. Please charge fully before first use to ensure optimal
performance. Plug the full sized USB plug of the included charging cable into any USB power
source such as a power cube, computer or car charger. Pull back the port cover and insert the
micro USB plug into the charging port. A red light indicates charging is in progress. The light
changes to green when charging is complete. Do not use the light while charging. Remove the
cable and close the port cover.
Charging a Smartphone: Pull back the port cover. Using your own phone charging cable,
connect the full sized USB plug into the flashlight's USB port. Connect the other end to your
device. Remove cable and replace the port cover.
Side Mounted Light: Repeatedly pressing the power button cycles between white high and low
brightness, red flashing and solid amber light modes plus off
Plasma Torch: Unscrew the glass breaker cap at the top of the light. Long press the plasma
torch button located adjacent to the power switch. Press the activated plasma torch against
your desired combustible material. NOTE: You MUST make contact with the combustible
materials! You may need to block wind to successfully start a fire. Release the button and
replace the glass breaker cap.
Glass Breaker: Grasp the shaft of the light firmly and strike the glass with the glass breaker tip
located at the top of the light. NOTE: Glass is easier to break in the corner of a car window.
Multi Function Pocket Clip, Saw, Wrench, Bottle/Can Opener
NOTE: Leave the protective cover on when using as a pocket clip.
Assembly: To assemble the multifunction clip for use, unscrew the glass breaker cap at
the top of the light and slide the clip off. Unscrew the bottom portion of the light below
the words "Saw Install Placement" and the clip locking collar directly below it. Slide the
clip into the grooves face down and replace the clip locking collar tightly. IMPORTANT:
You must tighten the clip locking collar firmly before use! Remove the saw blade cover
by pulling back on the release lever.
Saw: The saw blade is suitable for cutting branches or wood with a diameter of ¾" or
less. Carefully use the saw with a conventional back and forth motion.
Multi Wrench: The clip has cutouts for 25/64", 5/16", 17/64", 17/64", 3/16" and 5/32"
sized nuts.
Bottle/Can Opener: To open a conventional metal can, position the hook of the cutter
below the outer ridge of the can's rim and push the pointed cutter into the can lid
against the other side of rim, making a hole. Repeat the process around the entire rim
until you can lift the lid open.