Related Manuals for Holman 4A95L
Summary of Contents for Holman 4A95L
- Page 1 Instruction Guide 4A95L Holman Rancho Cordova, CA 95742 800-343-7486 InstallationSupport@Holman.com 20230831R3 DATE: ________________...
-
Page 2: Table Of Contents
9/16” Wrench and Socket Tape Measure Before You Begin • Read all instructions prior to assembling or installing any Holman product. • Have mount kit installed on vehicle. • DO NOT EXCEED MANUFACTURERS ROOF WEIGHT RATING. • Place sealant around all tube connections to ensure water does not get inside of rack. -
Page 3: Parts List
Instructions – 4A95L Parts List For Technical Support Call: 800-343-7486, Monday-Friday, 7AM - 4 PM (PST) Page 2... -
Page 4: Hardware
Instructions – 4A95L Hardware For Technical Support Call: 800-343-7486, Monday-Friday, 7AM - 4 PM (PST) Page 3... -
Page 5: Step 1 - Determine Bows
Instructions – 4A95L DO NOT EXCEED MANUFACTURERS WEIGHT CAPACITY FOR ROOF. Step 1 – Determine Bows • Determine front and rear bow. The triangular piece should be FRONT facing each other on each bow. REAR Step 2 – Pan Mount •... -
Page 6: Step 3 - Determine If Extension Is Needed
Instructions – 4A95L Step 3 – Determine if Extension is Needed • Measure between the two bows as shown. If distance is approximately 84.5”, the extension will be needed. • If the distance between the two bows is approximately 60”, the extension piece is not needed. -
Page 7: Step 5 - Install Cross Tube
Instructions – 4A95L • Bolt torque tube to front and rear bow using 1/4"-20 x 1” Hex Head bolt, two 1/4" flat washers and 1/4" lock nut at each location. Step 5 – Install Cross Tube • Insert crosstube as shown. -
Page 8: Step 6 - Install Latch
Instructions – 4A95L Step 6 – Install Latch • Move rear pan assembly out of Shown without pan for clarity. the way to expose the end of the crossmember. • Bolt latch assembly to end of crossmember using 5/16” x 1" carriage bolts, 5/16”... -
Page 9: Step 7 - Install Handle
Instructions – 4A95L Step 7 – Install Handle • Place handle in orientation shown. Attach handle to the rear pan using existing 5/16” hardware. • Repeat at both ends of rear bow. • Place sealant around tube connection. • TIGHTEN. -
Page 10: Step 8 - Ladder Stop
Instructions – 4A95L Step 8 – Ladder Stop • Attach ladder stop to both front and rear bow. Be sure the flange of the ladder stop is aligned with the cut out in the bows. • In the front bow, bolt in place using 3/8”... - Page 11 Instructions – 4A95L Step 9 – Assemble Ladder Hooks Note: Before use the ladder hook must be adjusted to an appropriate height for the ladder that will be used. The height of the hook needs to be at least 1/4" greater than the ladder. The ladder should fit loosely on the hook, not snug.
- Page 12 Instructions – 4A95L Step 11 – Install Ladder Hooks • Using the hardware and installed studs on both bows, loosen nuts and slide ladder hook assembly into place. • Tighten. DO NOT USE IMPACT WRENCH! GO BACK AND TIGHTEN ALL BOLTS FROM PREVIOUS STEPS, BE SURE HARDWARE IN MOUNTING IS TIGHT.
Need help?
Do you have a question about the 4A95L and is the answer not in the manual?
Questions and answers