1. Manuals
  2. Brands
  3. Holman Manuals
  4. Ladders
  5. 4A816
  6. Instruction manual

Holman 4A816 Instruction Manual

Hide thumbs

Advertisement

Table of Contents

Instruction Guide
4A816
Holman
Rancho Cordova, CA 95742
800-343-7486
InstallationSupport@Holman.com
20221014R2
DATE: ________________

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 4A816 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Holman 4A816

Summary of Contents for Holman 4A816

  • Page 1 Instruction Guide 4A816 Holman Rancho Cordova, CA 95742 800-343-7486 InstallationSupport@Holman.com 20221014R2 DATE: ________________...

  • Page 2: Table Of Contents

    Instructions – 4A816 PLEASE READ ALL INSTRUCTIONS AND WARNINGS PRIOR TO ASSEMBLING, INSTALLING, AND USING THIS PRODUCT. Warning Always check for wires, fuel tanks and lines, brake lines and other important vehicle functionality items prior to drilling and installing all products.
  • Page 3 Instructions – 4A816 Parts Hardware For Technical Support Call: 800-343-7486, Monday-Friday, 7AM - 4 PM (PST) Page 3...

  • Page 4: Step 1 - Remove Front Bow Ladder Hook And Stop

    Instructions – 4A816 Step 1 – Remove Front Bow Ladder Hook and Stop  Remove the ladder hook from the front bow.  Keep hardware for future use.  Remove the ladder stop from the front bow.  Where the ladder stop is removed, replace hardware and tighten.

  • Page 5: Step 2 - Remove Rear Bow Ladder Hook Hardware

    Instructions – 4A816 Step 2 – Remove Rear Bow Ladder Hook Hardware  Remove the ladder hook hardware (washer and nut) from the front side of the rear bow only.  Keep hardware for future use. Step 3 – Install Upper Support Tube Assembly ...
  • Page 6 Instructions – 4A816  At the rear bow, the upper support tube assembly will sit on top of the ladder hook.  Attach the upper support tube assembly using a 5/16” flat washer and a 5/16” lock nut at both locations.

  • Page 7: Step 4 - Install Extension Pan

    Instructions – 4A816 Step 4 – Install Extension Pan  Determine the correct location for the extension pan based on the size of the ladder.  Place the extension pan in the orientation shown and in the desired location on top of the already installed end tube and the upper support tube assembly.

  • Page 8: Step 5A - Install Ladder Hook

    Instructions – 4A816  Use the large clamp to attach the extension pan to the end tube. Bolt into place using the pre- installed threaded stud, a 5/16” flat washer and a 5/16” lock nut.  DO NOT OVER TIGHTEN. USE A RATCHET OR WRENCH TO HAND TIGHTEN ONLY.

  • Page 9: Step 5B - Install Ladder Hook Onto Alternate Position (Optional)

    Instructions – 4A816 Step 5B – Install Ladder Hook onto Alternate Position (Optional) Note: Follow the instructions in this step to install the ladder hook onto the alternate location, when using a wider ladder or the wide end of a stepladder.

  • Page 10: Step 6 - Install Ladder Stop

    Instructions – 4A816 Step 6 – Install Ladder Stop  Place the previously removed ladder stop over the slot towards the end of the pan.  Line up the flange of the ladder stop inside the square cut out on the pan.

Table of Contents