Jumpers Setup - ASROCK A780GMH-128M Installation Manual

Hide thumbs Also See for A780GMH-128M:
Table of Contents

Advertisement

2 . 7
2 . 7
2 . 7

Jumpers Setup

Jumpers Setup
Jumpers Setup
2 . 7
2 . 7
Jumpers Setup
Jumpers Setup
The illustration shows how jumpers are setup.
When the jumper cap is placed on pins, the
jumper is "Short". If no jumper cap is placed on
pins, the jumper is "Open". The illustration
shows a 3-pin jumper whose pin1 and
pin2 are "Short" when jumper cap is placed on
these 2 pins.
Jumper
PS2_USB_PW1
(see p.2, No. 1)
Note: To select +5VSB, it requires 2 Amp and higher standby current provided by
power supply.
Clear CMOS Jumper
(CLRCMOS1)
(see p.2, No. 24)
Note: CLRCMOS1 allows you to clear the data in CMOS. The data in CMOS includes
system setup information such as system password, date, time, and system
setup parameters. To clear and reset the system parameters to default setup,
please turn off the computer and unplug the power cord from the power supply.
After waiting for 15 seconds, use a jumper cap to short pin2 and pin3 on CLRCMOS1
for 5 seconds. However, please do not clear the CMOS right after you update the
BIOS. If you need to clear the CMOS when you just finish updating the BIOS, you
must boot up the system first, and then shut it down before you do the clear-
CMOS action.
2 2
2 2
2 2
2 2
2 2
ASRock
Short
Setting
Default
Clear CMOS
A780GMH/128M
Motherboard
Open
Short pin2, pin3 to enable
+5VSB (standby) for PS/2 or
USB wake up events.

Advertisement

Table of Contents
loading

This manual is also suitable for:

A780gmh128m-2180

Table of Contents