Download Print this page

ZINK Otley ZN34354-E Manual

Outdoor slimline led flood

Advertisement

Quick Links

Otley Outdoor
Slimline LED Flood
INS ZN 34354 34355 34356 34357 34358 - E
Diagram:
bolts
Brackets
Specification:
Voltage
Power factor
Wattage
10W
Lumen
800lm
Lamp type
CRI
Material
Beam angle
Products size
103x105x24mm
Color Temp
Work Temp
Protection
Housing color
Important Safety Information
Do not wire this floodlight into the lighting circuit - use a switched fused spur
Before installation and servicing, disconnect the electrical supply at the mains.
Carefully observe all instructions or warnings that are labelled on, or supplied with, your product.
This product is suitable for outdoor use. If in any doubt, consult a qualified electrician.
General Information
Do not mount ceiling/wall fittings onto damp surfaces such as newly painted or plastered areas
as this may cause discolouration of the finish.
Tools which may be required:
• Drill
• Cross Head Screwdriver
• Small Electrical Slotted Screwdriver
• Insulation Tape
AC180-260V
20W
1600lm
2400lm
SMD2835
Aluminum Alloy
160x145x25mm
160x145x25mm
Warm white:3000-3500K, Netural white : 4000-4500K, Daylight : 6000-6500K
-20
White ,Black ,Yellow
10W IP65
>0.9
30W
50W
4000lm
>80
180 °
206x183x33mm
°
°
C
C
----50
IP65
.
Aluminum Alloy
Tempered glass
Cable connection
100W
8000lm
270x236x33mm

Advertisement

loading
Need help?

Need help?

Do you have a question about the Otley ZN34354-E and is the answer not in the manual?

Questions and answers

Summary of Contents for ZINK Otley ZN34354-E

  • Page 1 Otley Outdoor Slimline LED Flood INS ZN 34354 34355 34356 34357 34358 - E Diagram: Aluminum Alloy Tempered glass bolts 10W IP65 Brackets Cable connection Specification: Voltage AC180-260V Power factor >0.9 Wattage 100W Lumen 800lm 1600lm 2400lm 4000lm 8000lm Lamp type SMD2835 >80 Material...
  • Page 2 Fixing instructions Do not wire this floodlight into the lighting circuit - use a switched fused spur. This fitting must be earthed. contact a qualified electrician to install a suitable earth facility. Ensure the electricity is turned off at the mains before installing or maintaining any electrical fitting. Please note: For new installations, check for any electrical cables or pipe work (gas/water) in the vicinity of the intended mounting point for this product, before proceeding with the installation.

This manual is also suitable for:

Otley zn34355-eOtley zn34356-eOtley zn34357-eOtley zn34358-e