Flipo FLIPSTER Instruction Manual

FLIPSTER™
ULTRA-STUNT RC GLOW CAR | Instruction Manual
Please read this instruction manual carefully before using.
• For Ages 3+
• Adult guidance is strongly recommended.
FIGURE A
BATTERY INSTALLATION
REMOTE CONTROL
1. Loosen and remove the lock screw located on the rear of your remote control and remove the battery compartment lid.
2. Insert 2 AA batteries according to the polarity information located in the compartment; make sure the (+) and (-) poles
of each battery are positioned correctly.
3. Replace the battery compartment door and screw; tighten screw completely to lock in place.
CAR
1. Loosen and take out the lock screw located on the rear of your Flipster and remove the battery compartment lid.
2. Insert 3 AA batteries according to the polarity information located in the compartment; make sure the (+) and (-) poles
of each battery are positioned correctly.
3. Replace the battery compartment door and screw; tighten screw completely to lock in place.
OPERATION
1. The Flipster is activated by moving the red toggle switch located on the bottom of the vehicle to the ON position. To
deactivate, move the switch to the OFF position
2. Your vehicle is paired to the remote control once batteries have been installed.
3. Drive the car by operating the white buttons on your remote control (Figure A).
SPINNING STUNT MOVES – Your Flipster is capable of any number of spins, turns, wheelies and other stunts. To do so,
simply move your Flipster backward or forwards while also pushing one of the buttons on the right side of the remote that
make the front axle twist. Different combinations of pushing these buttons will create different tricks! (Figure B)
GLOW-IN-THE-DARK FEATURES
The Flipster's wheel hubs, windshield and stunt wheels all glow in the dark. For this function to work, your Flipster must
be exposed to bright light. For best results, expose to sunlight.
FIGURE B
Wheelie Stunt