Cole & Bright Radar 360+ Linkable Jakob Magnet Quick Start Manual page 5

SMART LIGHT SETTINGS
Radar 360˚ is super smart and also has 2 light settings on the same switch
that is used to link the lights. Take note of the markings above and to the
right of the switch.
H
Goes from NO light to FULL brightness when
triggered. After about 30 seconds lights turns off.
L-H Always remains on LOW AMBIENT when the sun
goes down but goes to FULL brightness when
triggered. After about 30 seconds lights turns
back to LOW AMBIENT.
IF YOU WANT YOUR RADAR 360˚ LIGHTS UNLINKED
Radar 360˚ lights can be linked to other Radar 360˚ Linkable lights
OR used unlinked on a standalone basis.
Standalone Basis
If never previously linked simply charge your light and set to "M" or "S" position.
Unlinking your Radar 360˚ Lights
1. To remove a light from the linked network for use
as a standalone, switch the light you wish to
remove to the "S" position (far right).
2. Press and hold the LINK button for more than
10 seconds.
3. Once the light changes from flashing to solid, the linked light has been
unlinked to the network. Other linked lights will not be affected.
4. Release the LINK button.
5. Now turn OFF and back on - either to the "M" or "S"
position to enable the light to function normally.
You are now free to relocate your light to another unlinked location.
LOCATING LIGHTS IN THE NETWORK FOR BEST RESULTS
Radar360˚s has ultrasensitive sensors that detect movement at up to
7 metres in any direction from the light.
We recommend that you link your lights around 5m apart for best results.
If you locate a Radar360˚ light in the vicinity of windows or glass doors,
movement indoors will likely trigger the sensors and turn the light on. This
might be a nuisance in a high traffic area.
Therefore locate your lights in a position that is unlikely to set off your
Radar360˚ light from incidental movement inside your house.
H
OFF
M
H
OFF
M
H
OFF
M
H
OFF
M
L-H
S
L-H
S
L-H
S
L-H
S